1.
The Research of Behaviour at Column to Beam with End-plate Connection Joints by the Single Direction Bolts;
单面锁紧螺栓端板连接钢框架梁柱节点力学性能研究
2.
Engine Cylinder Head Bolt Tightening Sequence
引擎汽缸头螺栓锁紧顺序
3.
Hexagon head bolt and serrated lock washer external teeth assemblies
GB/T9074.16-1988六角头螺栓和外锯齿锁紧垫圈组合件
4.
Simple: Compared to flange, its more light, the locking machine is designed handiness, the bolt quantity are few, does not need to holeblockage.
简易它比法兰轻、锁紧机械设计巧妙，螺栓数量少，无须对孔对锁。
5.
Prevailing torque type all-metal hexagon nuts with flange
GB/T6187-1986全金属六角法兰面锁紧螺母
6.
Turn the hollow bolt so that it is fixed on the bake cover or the flange plate.
安装后必须旋出空心螺栓锁紧在电机后端盖或法兰盘上。
7.
When in place, the gasket should not extend beyond the end of the pipe( Fig.3).
为了如图1所示正确定位法兰，应该首先紧固两个锁定螺栓。
8.
" Surface discontinuities of fasteners on bolts, screws and studs for general requirements"
GB/T5779.1-1986紧固件表面缺陷--螺栓、螺钉和螺柱--一般要求
9.
Surface discontinuities of fasteners on bolts screws and studs-Special requirements
GB/T5779.3-1986紧固件表面缺陷--螺栓、螺钉和螺柱--特殊要求
10.
Prevailing torque type hexagon nuts with flange (with non-metallic insert)
GB/T6183-1986非金属嵌件六角法兰面锁紧螺母
11.
Experiment on Bearing Capacity of Single Angle Struts with One-sided Bolt Connection
单面螺栓连接单角钢压杆的承载力试验
12.
tightening bolt
拉紧螺栓，(铁)风口拉杆
13.
Improper bolt tightening procedure.
螺栓拧紧程序错误。
14.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
15.
square collar-head set-bolt
方头凸缘端紧定螺栓
16.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
17.
Side view of hexagonal jam nut. Selection box height represents thread diameter.
六角锁紧螺母的侧面图。选择框高度代表螺纹直径。
18.
reverse anchor jam nut
反向锁闭机构紧固螺帽