1.
transistor PWM converter for AC main spindle drive
交流主轴驱动晶体管脉宽调制变频器
2.
Research and Development of the Full-digital AC Main-spindle Drives;
全数字交流主轴驱动系统的研究和开发
3.
The Application of MITSUBISHI AC Servo Spindle Drive System in CNC Machining Center
三菱交流伺服主轴驱动系统在数控加工中心上的应用
4.
shaft-driven oil pump
主轴(驱动的)油泵
5.
clock, master, battery, accumulator or mains powered
主时钟,由电池、蓄电池或交流电源驱动
6.
Development of Driver Card of Distributed Multi-axis AC Servo Motion Control System;
分布式多轴交流伺服运动控制系统驱动板的研究
7.
Synchronous Control for Crankshaft Grinder Head-tail Stock Based on AC Servo
基于交流伺服驱动的曲轴磨床头尾架同步控制方法
8.
alternating current shaft generator
主机)轴带交流发电机
9.
Simulation of Self-sensing Technique for 3-phase AC Active Magnetic Bearings
三相交流主动磁轴承位移自检测技术仿真研究
10.
Parameter Design and Characteristic Analysis for Three-Phase AC Active Magnetic Bearing
三相交流主动磁轴承参数设计与特性分析
11.
single-speed alternating current electric drive
单速交流电电力驱动
12.
generator, alternating current, water wheel driven
交流水轮驱动发电机
13.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
14.
Thus a normal loom has two shafts. The main shaft(crankshaft or top shaft) drives the lay mechanism and is geared to another shaft which operates at half of the speed of the crankshaft.
这样,普通织机应具备两根轴,主轴(曲拐轴或位于上部的轴)驱动筘座并通过齿轮驱动另一根轴。
15.
Drive axle (4WD), tube axle (2WD)
驱动轴（4轮驱动），管轴（2轮驱动）
16.
At the rear end of the crankshaft is attached the flywheel, and at the front end are the driving wheels for the timing gears, fan, cooling water and alternator.
曲轴的后端连接着飞轮，前端是连接着定时齿轮，风扇，冷却水和交流发电机的驱动轮。
17.
Development of Master/Slave Structure Monitoring and Controlling Software for All-Digital AC Servo Drivers
全数字交流伺服驱动主从式网络监控软件的开发
18.
Individual infinite variable speed drive of each roll with AC-motors coupled to programmable frequency inverters.
电机驱动方式为交流变频无极变速驱动。