1.
Research on Reasonable Blank-Holder Force and Deep-drawing Limit of a Conical Part;
圆锥形零件极限拉深系数及合理压边力的研究
2.
The Study of Optimum BHF during Intellectual Control of Conical Part Deep Drawing;
圆锥形件拉深成形智能化控制中合理压边力规律的研究
3.
A Double-acting Hydraulic-mechanical Driving Press with Bi-bar Toggle Force Amplifier Based on Rolling Higher Pair
基于滚动高副的双边铰杆增力双向作用液压-机械复合传动压力机
4.
The perfect camber design can be obtained by introducing the center/side ratio concept of contact pressure and choosing proper ratio.
同时引入辊间接触压力的中、边部比值概念并作合理选择，使设计出的辊型更加完善。
5.
Regenerative braking control strategy for wheel drive hydraulic hybrid vehicle
轮边驱动液压混合动力车辆再生制动控制策略
6.
Bending of thick rectangular plates with adjacent simply supported,one fixed and one free edges under hydrostatic pressure
静水压力作用下复合边界条件厚矩形板的弯曲
7.
Blank-Holder Force Control in Deep Drawing of Rectangular Parts of AZ31 Magnesium Alloy Sheet
AZ31镁合金板料矩形件拉深分块压边力控制
8.
Theoretical and Experimental Research on Edge Stresses of Pressure Vessel;
压力容器边缘强度的理论研究与实验分析
9.
Design of mechanical subassembly with multi-point variable blank holder force
机械式多点变压边力压边组件的设计
10.
Design Optimization of Variable Binder Force in Sheet Metal Forming based on the Surrogate Model Guiding Sample
基于代理模型引导采样的薄板冲压成形变压边力优化
11.
The pressing of bottom, side attaching and forward-and-backward squeezer can be finished at one time, and also can be finished separately with high pressure and fastness.
压底、压边及前后束紧，可一次完成，亦可选择单个动作完成，具有压力大，压合牢固之特点。
12.
twin-geared press
双边齿轮驱动压力机
13.
COMBINING OPTION THEORY WITH MODELING FOR BILATERAL OPTIONAL ELECTRICITY FORWARD CONTRACTS;
结合期权理论的双边可选择电力远期合同模型
14.
Fundamental Study on the Hybrid-driven Programmable Mechanical Press;
混合驱动可控压力机的基础理论研究
15.
The Study on Rational Flooding Pressure in Casing Damage Area of No.2 Block of Pubei;
葡北二断块套损区合理注水压力研究
16.
Methods of Determining Reasonable Formation Pressure by Using Production Performance Data
利用生产动态资料确定合理地层压力
17.
3D coupled thermo-mechanical analysis and optimal design of hot extrusion die for polygonal aluminum profile
多边形铝型材热挤压模三维热力耦合分析与优化设计
18.
LIMIT STRENGTH OF LIPPED H-SECTION MEMBERS UNDER BOTH COMPRESSION AND BENDING
卷边翼缘工形构件在压弯荷载作用下的稳定承载力设计理论