1.
The Research on CAD/CAM for High-speed Wire Electro-Discharge Machine;
高速走丝电火花线切割机CAD/CAM研究
2.
Analysis on Machining Precision with Hs-Wedm and the Developing Trend of Wedm;
高速走丝电火花线切割机加工精度分析及今后的发展方向
3.
Study on Mechanism of High-Speed Wire Electrical Discharge Finishing in Gas;
高速走丝气中电火花线切割精加工机理研究
4.
NC slow-feeding wire-cut EDM machine
数控慢速走丝线切割电火花机床
5.
Design and Simulation of the Wire Drive Mechanism on WEDM-LS
低速电火花线切割机走丝机构的设计与仿真
6.
Study on Mechanism of Low-Speed Wire Electrical Discharge Finishing in Gas;
低速走丝气中电火花线切割精加工机理研究
7.
Development of Microcomputer Programming for Low Speed Wire Electrical Discharge Machining;
低速走丝电火花线切割微机编程软件的开发
8.
Key Technology Research on WEDM-HS CAD/CAM System;
高速走丝电火花线切割CAD/CAM系统关键技术研究
9.
Research on the Simulation System of High Speed WEDM;
高速走丝电火花线切割工艺仿真系统的研究
10.
Research on Modeling Method of HS-WEDM Process
高速走丝电火花线切割加工工艺建模方法研究
11.
Research of Wire-EDM-HS Turning Process
高速走丝电火花线切割车削加工的研究
12.
Research on Forming Reason of Cutting Surface Stripe in HSWEDM
高速走丝电火花线切割表面条纹的成因研究
13.
Design and Development the Control System of the HS-WEDM
高速快走丝电火花线切割机床数控系统设计与开发
14.
Discuss on Multi-Times Cutting Technology of Move Back and Forth Run-Wire WEDM
往复走丝电火花线切割机床多次切割技术探讨
15.
Research of Wire-Feeding System for WEDM-LS;
慢走丝电火花线切割机床走丝系统的研究
16.
The Study of Motion Control Mechanism of Low Speed Wire-Electric Discharge Machining Tool;
低速走丝电火花线切割机床运动控制机理的研究
17.
Research into High Efficiency and Low Wire Wear Machining Technology of WEDM-HS;
高速走丝电火花线切割高效率低损耗加工技术研究
18.
Research and Application of Numerical Control System of LS-WEDM;
低速走丝电火花线切割机数控系统的研究与应用