1.
Determination of Lead and Cadmium in Water by Flame Atomic Absorption Spectrometry after Separation/Pre-concentration with Manual-Controlled Injection Porous Nano-Barium-Strontium Titanate Microspheres Separator
手控注射式钛酸锶钡多孔球富集器分离富集-火焰原子吸收法测定水中铅和镉
2.
Injection System Control Analysis and Simulation Study of Ultra High Speed Injection Machine
超高速注射机注射控制的系统分析与仿真研究
3.
Study on Assessesment of Quality for Belamcanda Chinensis and Shegan Kang Bingdu Injection;
射干和射干抗病毒注射液的质量控制研究
4.
Attention: The detection zone can not be adjusted too long, in case that the basin gets a wrong induction and make the controller acts incorrectly.
注意：感应距离不能调节太长，以免洗手盘对感应信号有反射而使控制器有误动作。
5.
a hypodermic injection [needle, syringe]
皮下注射 [注射针,注射器]
6.
He injected my arm with penicillin.
他给我的手臂注射盘尼西林。
7.
Cellular Phone Outer Shell Injects the Mold Design and Application of CAD/CAE/CAM;
手机外壳注射模设计与CAD/CAE/CAM的应用
8.
The application of adjustable syringe handle in clinical biopsy
可调注射器手柄在临床活检中的应用
9.
Treatment of 112 Cases of Cervical Spondylopathy by Acupoint Injection and Massage
穴位注射加推拿手法治疗颈椎病112例
10.
Model Prediction Iterative Learning Control of Ram Velocity for Injection Molding Machines
注塑机注射速度的模型预测迭代学习控制
11.
Injection Velocity Control in Injection Molding by Iterative Learning Control with Zero-phase Filtering
注塑机注射速度的零相位滤波迭代学习控制
12.
Control of the chemical purity of WFI presents few major problems.
注射用水化学纯度的控制是主要问题。
13.
Research of an Online Measurement and Control System of Water-quality on FIA
流动注射式水质在线测控系统的研究
14.
Study on Process Control Chart and Process Capability of Water for Injection;
注射用水过程控制图及工序能力研究
15.
Study on the Method of Quality Control for Saussurea Involucrata (Kar.et Kir.)Sch. -Bip.Linnaea. and Its Injection;
雪莲及其注射液质量控制方法的研究
16.
Study on Quality Control of Ixeris of Sonchifolia Hance and Ixeris of Sonchifolia Hance Injection;
苦碟子及苦碟子注射液质量控制研究
17.
Study of Temperature Control System of Rubber Injection Machine;
橡胶注射机料筒温度控制系统的研究
18.
The Powder Injection Molding of ZrO_2 Samll Parts and the Dimension Precision Control;
ZrO_2小型零件粉末注射成形与精度控制