1.
Forms of quality defects of bending pipes made on bending machine and the solution to it
弯管机上弯管质量的缺陷形式及研究对策
2.
Quality Control of NC Tube Bending Process Based on the 3D FEM Simulation;
基于三维FEM模拟的数控弯管质量控制
3.
Determination of deflection for rigid plastic pipes
GB/T8805-1988硬质塑料管材弯曲度测量方法
4.
Quality Evaluation of Spiral Seam Cold Bending Pipe of X70 Steel
X70钢螺旋焊缝冷弯管的质量评价
5.
Study on Forming Quality Analysis and Improved Die of Bending Tube about Power Plant Boiler;
电站锅炉弯管成形质量分析及模具改进研究
6.
The Influence of Welding Process on the Quality of Welding Joints for the Rectangle Pipe
焊接工艺对冷弯方矩形管焊接接头质量的影响
7.
Studies on the measurement of the solid mass flowrate of the gas-solid two-phase flow by the double-elbow method;
双弯管法气固两相流固相质量流量测量方法的研究
8.
Comparison of Penetration and Obturation Density Using Nickel-titanium and Stainless Steel Finger Spreader in Curved Canals;
侧方加压器进入弯曲根管的深度及根充质量的实验研究
9.
Elbow flowmeter is one version of differential pressure flowmeters.
弯管流量计是差压法流量计的一种。
10.
determination of flexural properties of rigid plastics
硬质塑料弯曲度测量方法
11.
Effects of Proca Photon in Curved Spacetime;
弯曲时空中Proca光子的静质量效应
12.
The Construction Design of the Bending Die for Improving the Surface Finish of Parts;
提高工件表面质量的弯曲模结构设计
13.
This paper describes the principle of the elbow flowmeter.
本文介绍了弯管流量计的工作原理.
14.
These tubes are lightweight, soft and pliable.
这些管子重量轻，柔软易弯曲。
15.
The discharge coefficient for each elbow flowmeter should be calibrated in practice.
每个弯管流量计的流量系数须经过实际标定.
16.
This paper studies the application of incremental opticalelectrical encoder(IOE)to the bent tube measuring machine.
研究增量式光电编码器在弯管测量机上的应用。
17.
FEM Simulation of Bending Deformation and Research on Quality Controlling for Truck Lengthwise Beam;
车架纵梁弯曲成形模拟分析及质量控制的研究
18.
Vibration Analysis of Kirchhoff Plates by the Nonconforming Element Method with Mass-Lumping;
薄板弯曲问题的集中质量非协调有限元模拟