1.
The Research and Realization on Dynamics Characteristic of CK61100 Numeric-Normal Lathe;
CK61100数普兼容车床动力学特性仿真研究与实现
2.
The Design and Research of Lathe with Two Operate Model Based on PMAC;
基于PMAC数普兼容式车床开放式数控系统的开发与研究
3.
mini capacitive-gate digital readout for lathe
微型车床容栅数显器
4.
On the Frame of Alteration of Ordinary Lathe to Numerical Control Lathe by Application of One-chip Computer;
运用单片微机改普通车床为数控车床的设计
5.
The Feasibility Proves on the Numerically Controlled Transform of Ordinary CA6140 Lathe;
CA6140普通车床数控化改造的可行性研究
6.
Implement of Circular Interpolation in Lathe NC Reconstruction
普通车床数控改造中圆弧插补的实现
7.
CNC Transformation on the Drive System of CA6140 Lathe
浅谈CA6140普通车床传动系统的数控改造
8.
The Numerical Control Modification of Ordinary CA6140 Lathe
CA6140型普通车床的数控化改造
9.
A few main points on the CNC lathe turning ordinary thread
浅谈数控车床车削普通螺纹的几个要点
10.
The Research on Variable Frequency Motor Driver with PC for CNC;
基于PC机的普通数控车床变频调速系统的研究
11.
The Applicationg of AHP on the Evaluationg of General Lathe s Numerically Controlled Reforming Plan;
基于层次分析法评判普通车床数控化改造方案
12.
Improvement of Tool-carrier and Analysis on Faults in NC Transformation of Traditional Lathe
普通车床数控改造中刀架改造及常见故障分析
13.
dard light and medium duty engine lathe
标准轻型和中型普通车床;标准轻中型普通车床
14.
Study the Influence of Wiring on the EMC of Automobile;
汽车布线对汽车电磁兼容的影响研究
15.
Study on Refitting a Common Lathe into the Special Equipment to Process End Face and Central Hole By Using Numerical Control Technique;
普通车床改装成数控加工端面及中心孔专用设备的研究
16.
The Study of the Software for Screw Thread Processing on General NC Lathe and Interpolantion Algorithm Based on PC;
基于PC机的普通数控车床螺纹加工软件及插补算法的研究
17.
Overview of Establishment and Operation of the Exemplary Base for the Exemplary Program for Conventional Lathe;
普及型数控车床示范工程示范点的建立及运行概论
18.
Reformation of Feed System in Lathe Based on 16 Bit Single Chip Microcomputer Control
基于16位单片机控制的普通车床进给系统数控改造设计