1.
square collar-head set-bolt
方头凸缘端紧定螺栓
2.
Fatigue Reliable Analysis on Fastening Bolt of Generator Stator Core
发电机定子铁芯紧固螺栓疲劳可靠性分析
3.
tightening bolt
拉紧螺栓，(铁)风口拉杆
4.
Improper bolt tightening procedure.
螺栓拧紧程序错误。
5.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
6.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
7.
Mounting Bolts (Screws)—IAC Motor
固定螺栓（螺丝）—IAC马达。
8.
When in place, the gasket should not extend beyond the end of the pipe( Fig.3).
为了如图1所示正确定位法兰，应该首先紧固两个锁定螺栓。
9.
a hand tool that is used to hold or twist a nut or bolt.
用来上紧或扭螺母或螺栓的手工具。
10.
Fasteners--Clearance holes for bolts and screws
GB/T5277-1985紧固件螺栓和螺钉通孔
11.
Install differential case and dummy bearings in axle housing (without shims) and tighten retaining cap bolts.
在轴壳内（没有垫片）安装差速箱和模型轴承，并紧固固定帽螺栓。
12.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
13.
" Mechanical properties of fasteners--Bolts, screws and studs"
GB/T3098.1-1982紧固件机械性能螺栓、螺钉和螺柱
14.
Rear Mount To Body Bolts
后固定座与车身螺栓
15.
LEFT ENGINE MOUNT BRACKET LOWER BOLTS
左引擎固定支架下螺栓
16.
Remove caliper mounting bolts .
拆卸夹制器固定螺栓。
17.
hydraulicdevice for tightening tie-bolt
贯穿螺栓上紧用液压装置
18.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈