1.
the paper focuses on the axial locking mechanism of φ160mm & 45°framed two-roll finishing rolling mill.
本课题以“Ф160框架式45°两辊钼线材精轧机的轴向紧定机构”为研究对象。
2.
Study and Improvement on the Axial Locking Mechanism of Φ160mm & 45°Framed Two-High Finishing Rolling Mill for Molybdenum Wire;
Φ160框架式45°两辊钼线材精轧机的轴向紧定机构研究及改进
3.
four high continuous hot strip mill
四辊连续式带材热轧机
4.
four high reversing cold strip mill
四辊可逆式带材冷轧机
5.
Optimization of Intermediate Roll Shape Curve for Six High Reversing Cold Rolling Mill with One Stand
六辊单机架可逆冷轧机中间辊辊型曲线优化
6.
Analysis and handling of faults for the finish rolling drum of high-speed wire rod mill
高速线材厂精轧辊箱故障分析及处理
7.
precise bar mill with rapid roll change
带快速换辊装置的精密棒材轧机
8.
Failure Research of the Inputting Shaft for the High Speed Wire-rod Finishing Mill in Chang Gang;
长钢高速线材精轧机夹送辊输入轴断裂失效研究
9.
Main Points for the Installation and Overhaul of High-speed Wire Finishing Mill Unit With 45° Top Crossing
顶交45°高线精轧机组的安装检修要点
10.
There are two ways of producing molybdenum wires, rolling-drawing and swaging-drawing.
目前国内钼线材加工方式有两种:轧制-拉伸加工与旋锻-拉伸加工。
11.
huller roll - box
气流式轧花机的轧辊箱
12.
IMPROVEMENT ON ROLL MATERIAL AND PROFILE OF ASSEL MILL
阿塞尔轧管机轧辊材质与辊型的改进
13.
Design of Roll Shape for 8 High Roll of TCM
八辊冷连轧轧机的一种辊型曲线设计
14.
Garrett looping rod mill
加勒特活套式线材轧机
15.
ANALYSIS ON THE SAFETY OF Y370 WIRE ROD ROLLING MILL
Y370三辊线材连轧机组安全系统优化分析
16.
End contour of intermediate rolls for a UCMW cold tandem mill
UCMW冷连轧机组各架中间辊端部辊形
17.
a rolling mill consists of two parts: the mill stand and the driving device. a set of roils is held in a housing (or stand).
轧机由两部分组成:轧机机座和驱动装置。轧辊组安装在牌坊上(即机架上)。
18.
Assel elongator
阿塞尔三辊式轧管机