1.
Method of Controlling Low Effective Injection Production and Tapping Remaining Oil Within Layer in Lamadian Oilfield;
喇嘛甸油田层内低效注采调整与剩余油挖潜方法
2.
The Research in Identifying the Low and Non-effective Injection-production Circulation Layers by Using Monitoring Technology
利用监测技术识别低效无效注采循环体技术研究
3.
AN ANALYSIS OF PROSPECT OF EOR BY GAS INJECTION IN LOW-PERMEABILITY OIL RESERVOIR
低渗透油藏注气提高采收率前景分析
4.
A complete set of EOR technology by gas injection in low permeability oil reservoirs.
低渗透油藏注气提高采收率配套技术
5.
Research on Reasonable Injection-production System in Ultra-low Permeable Oilfield of Jilin
吉林特低渗透油田合理注采系统研究
6.
Effective measures to control ore dilution ratio and mining loss rate in mine stope
降低采场矿石贫化率和采矿损失率的有效措施
7.
The study on injection-production well distance and injection effective time in Shiwu Oilfield
十屋油田注采井距与注水见效时间研究
8.
Take effective measures to reduce the discharge to the minimum.
采取有效措施,将排放降至最低水平。
9.
Effect Evaluation of One Gas Injection and More Exploitation in the Later Stage of Taking in and Sending out Inspissated Pools in Wa 38 Block
小洼油田吞吐后期一注多采效果评价
10.
Study of the Recovery Effect of Superheavy Oil with CO_2 Injection
注CO_2改善超稠油开采效果研究
11.
Using protection cast process in the whole course to debase the content of gas and inclusion.
采用全程保护浇注工艺降低气体和夹杂物含量 ;
12.
EOR MECHANISM BY UNSTABLE WATER INJECTION IN ULTRA-LOW PERMEABILITY OILFIELDS
特低渗透油田不稳定注水提高采收率机理探讨
13.
Research on the Low Temperature Heating Design Process and its Questions
低温采暖设计过程以及应注意的问题研究
14.
Questions deserving attentions in design of low temperature hot water floor radiation heating system
低温热水地面辐射采暖设计应注意的问题
15.
Experiment of improved oil recovery by air foam injection low temperature oxidation process
注空气泡沫低温氧化工艺提高采收率试验
16.
Calculating the limit injector-producer distance in low permeability pool by with start-up pressure gradient
利用启动压力梯度计算低渗油藏极限注采井距
17.
The molten metal may enter the ingot mould in two ways: from the top and from the bottom. Top pouring is the simplest and cheapest method, but gives poor control over the rate of pouring.
钢液注入钢锭模可采用两种方式:上注和下注。上注法最简单,成本最低,但不好控制浇注速度。
18.
The Study of Dynamic Simulation in Mudstone Rheology and Optimum Balance of High Pressure of Injection and Production;
高压注采条件下岩石流变效应及最优注采平衡动态模拟研究