1.
STUDY ON THE CHARACTERISTIC OF CONTACT LINE IN A TRIANGLE-WETTING REGION OF RECTANGULAR CAPILLARY MICROGROOVES
矩形毛细微槽中三角形区域接触线特性的研究
2.
Design and manufacturing and performance analysis of rectangular micro-groove heat pipe
微矩形槽平板热管的设计制造及性能分析
3.
The numerical simulation on heat transfer performance of rectangular micro channel plate heat pipe
微小型矩形槽道平板热管传热性能的数值模拟
4.
THE VISUALIZATION OF MICRO-BUBBLE DYNAMIC BEHAVIOR IN CAPILLARY MICROGROOVES
毛细微槽中汽泡动力学行为可视化研究
5.
A beam of channel croas section was analysed closely,. its large deformation and critical moment was given.
本文仔细分析了一个槽形截面梁的大变形并给出了其临界弯矩。
6.
Visualization of Bubble Dynamic Behaviors in Open Capillary Microgrooves
开放式毛细微槽群中汽泡动力学行为的可视化研究
7.
The cilia were very densely packed together. Goblet cells covered by microvilli were found in the cilia forests.
纤毛丛生,纤毛丛中杂以被覆微绒毛的杯形细胞,纤毛膜光滑。
8.
a rectangular groove made to hold two pieces together.
使两块物连起来的矩形的凹槽。
9.
Numerical Simulation of Sloshing in Two Dimensional Rectangular Tanks with SPH;
二维矩形水槽晃荡过程的SPH方法模拟
10.
Investigation on Heat Transfer and Flow Performance of Rectangle Channel with Riblets Groove;
矩形条纹槽道传热和流动特性的研究
11.
Study on numerical simulation of static wind load of the double rectangular aqueduct
矩形双渡槽静风荷载的数值模拟研究
12.
STUDY ON CUTTING FORCE IN RECTANGULAR GROOVE CUTTING AND SIDE DEFORMATION OF CHIP
矩形槽切削的切削力及切屑横向变形的研究
13.
Preliminary Study on Forming Laws of Cuspidal Splitter Split-extruding Rectangular Slot
尖头劈楔劈挤矩形槽成形规律初步研究
14.
a rectangular groove cut into a board so that another piece can fit into it.
能够使得另一个板插进去的板上的一个矩形槽。
15.
Investigation on Heat Transfer and Flow Performance of Rectangle Channel with Active Control;
矩形槽道主动控制传热和流动特性的研究
16.
Analysis for Prestress Loss of Rectangle Aqueduct Concrete Structure with Multi-side Walls
多侧墙矩形渡槽预应力损失规律测试分析
17.
Finite element simulated analysis in operational process for Shahe prestressing rectangular aqueduct
沙河预应力矩形渡槽运营期有限元仿真分析
18.
Research on Cogging Torque Ripple Compensation at Low Speed for Direct Drive Ring Permanent Magnet Torque Motor
直接驱动环形永磁力矩电机低速齿槽转矩脉动补偿研究