1.
This paper proposed consult ideas about how to increase the pehtze production rate and improve the protein utilization ratio of raw materials.
就如何提高原料蛋白质利用率及白坯出坯率提出了参考意见。
2.
Precise preform loading system in order to minimize failure rate.
高可靠性的进坯、上坯、出坯系统、使吹瓶机故障率降到最低。
3.
Minimum Mould Exit Shell Thickness of Round Blooms for Peritectic Steel Casting
包晶钢圆坯结晶器出口安全坯壳厚度的研究
4.
In the injection stretch blow moulding process, injection moulding machine is used to make the preform.
注拉吹工艺先用注塑机注出瓶坯。
5.
The sculptor roughed out the form his statue should take.
雕刻师制出了雕像的毛坯。
6.
STUDY ON PARISON SWELL OF MODIFIED PVA IN EXTRUSION BLOW MOLDING
改性聚乙烯醇挤出吹塑型坯膨胀研究
7.
Temperature Estimation of a Heated Armor Plate′s Original Surface Based on Deferred Infrared Temperature-measuring
红外仪延迟测量法确定板坯出炉温度
8.
Reducing the Defext Rate of Spotty in Bloom by Utilizing 6σ
采用六西格玛工具降低矩形坯白点缺陷率
9.
THE INFLUENCE OF AIR CONSUMPTION COEFFICIENT TO CLEANING RATIO OF IRON OXIDE SCALE OF BILLET
空气消耗系数对钢坯铁皮除净率的影响
10.
Influence of Oxide Skin Thickness on Photoemissivity of Polarizing Angle from Surface of Continuous Casting Billets
氧化层厚度对铸坯表面偏振角发射率的影响
11.
Reasonable Control the Upper Crop End and Lower Crop End Weights,and Improve the Utilization Rate of Crankshaft Blank of Electroslag Remelting Ingot
合理控制切头切尾量,提高电渣钢曲轴坯成材率
12.
The initial shrinkage temperature and the shrinkage change little with the increase of heating rate.
升温速率增大,坯片开始收缩的温度及收缩率几乎不变。
13.
This machine applies to cutting the adobe strips extruded from plasticity or half-plasticity and use with single and double jaw brick-make machine.
本机适用于切割硬塑或半硬塑挤出的坯条，与单、双泥条挤出切坯配套使用。
14.
strong winds; a hard left to the chin; a knockout punch; a severe blow.
强风；很难把下巴转到左边；出坯杆；剧烈的喘气。
15.
Analysis of the Temperature of Slabs out of CCM in HCR Technology
热送热装工艺中板坯出连铸机温度的分折
16.
Effect of slab strain on Nb(C,N) precipitation in continuous casting process
连铸过程铸坯应变对碳氮化铌析出行为的影响
17.
Study on microstructure and precipitated phases in Al0.3Mn0.4Fe twin-roll casting Al-strip
Al_(0.3)Mn_(0.4)Fe合金铸轧板坯晶粒和析出相分析
18.
Study on Design and Optimization Techniques of Parison Thickness for Extrusion Blow Molding
中空挤出吹塑型坯壁厚设计与优化技术研究