1.
Research of Wire-Feeding System for WEDM-LS;
慢走丝电火花线切割机床走丝系统的研究
2.
The Development of Discharge Gap Control System for Wire Electrical Discharge Machining with Slow-Travelling Speed;
慢走丝电火花线切割机间隙控制系统的研究
3.
NC slow-feeding wire-cut EDM machine
数控慢速走丝线切割电火花机床
4.
The Research on CAD/CAM for High-speed Wire Electro-Discharge Machine;
高速走丝电火花线切割机CAD/CAM研究
5.
Discuss on Multi-Times Cutting Technology of Move Back and Forth Run-Wire WEDM
往复走丝电火花线切割机床多次切割技术探讨
6.
Study on Mechanism of Low-Speed Wire Electrical Discharge Finishing in Gas;
低速走丝气中电火花线切割精加工机理研究
7.
Key Technology Research on WEDM-HS CAD/CAM System;
高速走丝电火花线切割CAD/CAM系统关键技术研究
8.
Study on Mechanism of High-Speed Wire Electrical Discharge Finishing in Gas;
高速走丝气中电火花线切割精加工机理研究
9.
Research on the Simulation System of High Speed WEDM;
高速走丝电火花线切割工艺仿真系统的研究
10.
Development of Microcomputer Programming for Low Speed Wire Electrical Discharge Machining;
低速走丝电火花线切割微机编程软件的开发
11.
ENSURING QUALITY METHODS OF WEDM-HS;
确保数控快走丝电火花线切割加工质量的方法
12.
Command Formats Extension of DK Single Chip Micyoco for Rapid Moving Electric Discharge Wire-Cutting;
电火花快走丝线切割DK单片机指令格式的扩展
13.
Design and Simulation of the Wire Drive Mechanism on WEDM-LS
低速电火花线切割机走丝机构的设计与仿真
14.
Research on Modeling Method of HS-WEDM Process
高速走丝电火花线切割加工工艺建模方法研究
15.
Research of Wire-EDM-HS Turning Process
高速走丝电火花线切割车削加工的研究
16.
Research on Forming Reason of Cutting Surface Stripe in HSWEDM
高速走丝电火花线切割表面条纹的成因研究
17.
Analysis and Treatment of Wire Breakage in LS-WEDM Cutting;
低速走丝电火花线切割加工断丝原因分析及处理
18.
Research and Application of Numerical Control System of LS-WEDM;
低速走丝电火花线切割机数控系统的研究与应用