1.
Second Suggestion for Developing Bimetal Strip for Friction Resistant Bush
开发耐磨轴瓦用双金属带材的再建议
2.
The Study on Running-in and Wear Properties of Crankshaft-bearing Shell of Diesel Engine
柴油机曲轴-轴瓦磨合磨损性能研究
3.
The alloy is suitable for making wear resistant parts such as bush, axle sleeve and worm wheel etc. undor the conditions of high and middle load at the middle and low speed.
合金主要用于制作高、中载,中低速不同工况条件下工作的轴瓦、轴套、蜗轮等耐磨件。
4.
renew worn tyres, bearings, brake-blocks, etc
更换磨损的轮胎、 轴承、 闸瓦等
5.
The Study and Application of Mid-mangancse Alloy Cast Iron Brake Shoe
中锰合金耐磨铸铁闸瓦的研究与应用
6.
Study on Wear Resistance Behaviors of Hardening Coatings Sprayed on Corrugating Rolls Surface
瓦楞辊表面喷涂硬质涂层耐磨性研究
7.
Running-in wear simulation test for crankshaft journal-bearing shell of S50MC marine diesel engine
S50MC船用柴油机曲轴颈-轴瓦磨合磨损的模拟试验研究
8.
Use grinding-resist double mechanical seal. Reliable for sea water, muddy, waste water.
采用耐磨性特强之双头机械轴封、耐海水、污水、污泥之磨损。
9.
The Research of Laser Alloying Processing to Improve the Wear-Resistance of Stainless Steel Pump Shaft;
不锈钢轴的激光合金化提高耐磨性的研究
10.
Influence of Temperature on Friction and Wear Properties of Cu-10Sn-10Pb Anti-friction Composite Materials
铜铅轴承材料减摩耐磨性能及其温度的影响
11.
Comparative Study on Wear Resistance of Sliding Bearing Alloys Under Grease Lubrication
脂润滑条件下滑动轴承合金耐磨性能的研究
12.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
13.
boring machine for connecting rod and cylinder block bush
连杆瓦及缸体轴瓦镗床
14.
Test method for abrasion resistance of concrete and its products(Ball bearing method)
GB/T16925-1997混凝土及其制品耐磨性试验方法(滚珠轴承法)
15.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
16.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
17.
Crankshaft main journal out of round or worn
曲轴主轴颈不圆或磨损
18.
Replace crankshaft or grind journals
更换曲轴或磨光轴颈