1.
Kinematic Precision Analysis on Crankshaft Neck of Compound Follow-up Turning System
曲轴连杆颈复合跟随车削系统的运动精度分析
2.
Dynamical Analysis and Optimization on Crankshaft Neck of Compound Follow-up Turning Cutter Frame
曲轴连杆颈复合跟随车削刀架的动力学分析与优化
3.
Remove piston and connecting rods from crankshaft journals.
从曲轴颈上拆下活塞和连杆。
4.
"The connecting rod carries the power thrusts from the piston to the crankpin. At the same time, the rod is in eccentric motion."
"连杆的作用是将活塞承受的压力传给连杆轴颈。同时,连杆做偏心运动。"
5.
The main bearing journals fit into the cylinder block and the big end journals align with the connecting rods.
主要轴承曲颈安装在气缸体和与连杆大头末端匹配的曲颈上。
6.
Abstract: The article introduced a grinding method and principle of the journal of crankshaft connecting rod.
本文简述了一种正在兴起的曲轴连杆轴颈的磨削方法和原理。
7.
The design of a support with eccentricity for turning high-power 9 cylinders diesel engine crank pin
大型9缸柴油机曲轴连杆轴颈车削偏心扶架设计
8.
A rod or lever transmitting motion in a machine.
连杆机器中传递运动的连杆或杠杆
9.
The throw of the crankshaft, i.e. the distance between the main journal and the big end centers, controls the length of the stroke.
曲轴的摆幅，即在主要曲颈和连杆大头末端中心之间的距离，控制着冲程的行程。
10.
Disconnect stabilizer bar links at the axle.
断开车轴上稳定杆连杆。
11.
Variation laws of connecting rod curves for five bar and similar four bar mechanism
类四杆五杆机构连杆曲线的变化规律
12.
Install connecting rod bolt protectors on rod bolts.
在连杆螺栓上安装连杆螺栓保护件。
13.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。
14.
A pole connecting the rear axle of a vehicle with the front.
连接杆连接车辆前后轴的杆
15.
The Analysis of the Points Paths on Link of Plane Five-bar Linkages;
平面五连杆机构连杆上点的轨迹分析
16.
A beam that connects the piston rod to the connecting rod of a reciprocating engine.
十字头连接活塞杆和往复式发动机连杆的横杆
17.
Results The internal jugular vein(IJV) and the common carotid artery(CCA)join tightly to each other.
结果 颈总动脉与颈内静脉紧密相连 ;
18.
a dress with scallops around the neck
颈部镶荷叶边的连衣裙