1.
Fabrication and Thermal Shock Resistance of Ca-ZrO_2 Ceramics and FGMs with Porosity Gradient;
Ca-ZrO_2陶瓷及其孔隙率梯度材料的制备与抗热震性能
2.
resistivity-porosity cross plotting
电阻率-孔隙度交绘图法
3.
Seismic velocity can occasionally be affected by porosity and temperature.
孔隙率和温度有时也能影响地震波速。
4.
Porosity is defined as the ratio of the void space in a rock to the bulk volume of that rock multiplied by 100 to express in percent.
孔隙度定义为岩石内的孔隙体积占岩石总体积的百分率。
5.
Research on Relationship of Porosity-strength of Cement-based Materials and Construction of Porosity-strength
水泥石强度分析与孔隙率强度模型构造
6.
Rising temperature of casting solution will increase the water flux, porosity and average pore size of PVDF membrane.
制膜液温度升高，得到微孔膜的孔隙率、通量及平均孔径都增大。
7.
Pore Structure of the Plasma Sprayed Nanostructured ZrO_2 Gradient Thermal Barrier Coating
等离子喷涂纳米ZrO_2功能梯度热障涂层的孔隙结构
8.
Research on Effect of Silica on Porosity and Permeability During Steam Injection;
注蒸汽油藏SiO_2影响地层孔隙度和渗透率的研究
9.
An Interpretation of Reservoir Porosity and Permeability in Chaoyanggou Oilfield
朝阳沟油田储层孔隙度和渗透率解释方法
10.
The Determination of Porosity and Cellulose Content of Plant Fibers by Density Methods
纤维孔隙率的测量及密度法测量的纤维素含量
11.
Research into the relationship between microstructure fractal and porosity and compressive strength
微结构分维与孔隙率及抗压强度的关系
12.
In general, smaller grain size and greater angularity tend to increase the porosity while an increase in range of particle size tends to decrease porosity.
通常，颗粒越小曲率越大孔隙度越大，而当颗粒尺寸增大时孔隙度会减
13.
Along with the increase of deepness, to porosity and permeability, mudstone reduce much more than sandstone.
随深度的增加，泥岩孔隙度和渗透率降低的幅度比砂岩大。
14.
The porosity and permeability of reservoir are macroscopic reflection of microscopic reservoir pore structure characteristics.
储层孔隙度和渗透率参数是储层微观孔隙结构特征的宏观综合表现。
15.
velocity vs porosity relationship
孔隙度与速度关系图
16.
Porosity may be classified according to the mode of origins (1) original and (2) induced.
按其原始形态，孔隙度可分为原生孔隙度和次生孔隙度。
17.
The Influence of Re-sintering Temperature and the Blooming Density on CuPb24Sn Bearing Material Porosity and Metallic Phase
复烧温度与初轧密度对CuPb24Sn轴瓦材料孔隙率及金相的影响
18.
Comparative Study on Predicting Porosity by Different Roughness Indices
不同粗糙度尺度下预测表层土壤孔隙率量化指数比较研究