1.
Phenomenological Studies on Extrusion Swell of Polymer Melt Through Conical Short Dies;
聚合物熔体在圆锥短口模的挤出胀大唯象研究
2.
Characteristics of Dielectric Hybrid Mode Small-bore Conical Horns
小口径混合模介质加载圆锥喇叭特性分析
3.
Andthus a mathemacal model of the conicylindrical passage is built to obtain an equation for calculationof the demensional die.
文中建立圆锥形通道的数学模型，得到计算口模尺寸的计算公式。
4.
Theoretical Analysis on Polymer Melt Extrusion Swell at Conical Die with Different Entrance Angles
不同角度圆锥口模对聚合物熔体挤出胀大的影响
5.
Square set screws with short dog point and cone end
GB/T86-1988方头短圆柱锥端紧定螺钉
6.
The Theoretical Modeling of a Cylinder Going Through a Cone and Their Intersecting Curve;
圆柱贯穿圆锥的相贯线及其数学模型
7.
conical bite-sized piece of chocolate.
圆锥形的一口大小的巧克力。
8.
Optical Field Evolution and Transmission Characteristics of Ultra-short Pulse in the Tapered Region of a Single-mode Tapered Fiber
单模锥形光纤锥区光场及超短脉冲的传输特性
9.
Typical modes of Rupture of Thin Metal Circle Plates under Normal Impact of Different Conical-Nosed Missiles--Experiments;
薄金属圆板在圆锥头弹体正冲击下的破裂模式
10.
The Mathematical Modeling of A Cylinder Going Through A Cone and the Drawing of Their Intersecting Curve
圆柱圆锥正交相贯的数学模型及其交线画法
11.
Analytical model of range-Doppler image of rotating cylinders and cones
转动圆柱和圆锥的激光距离多普勒像分析模型
12.
Modal Analysis of Cone Scanning Radiation Antenna;
圆锥扫描辐射计天线装置的模态分析
13.
Numerical Optimization of Round Mould Taper for Continuous Casting Steel Slab
钢连铸圆坯结晶器锥度数值模拟优化
14.
Modeling and Simulation of the Bevel Gear Based on Pro/E and ADAMS
基于Pro/E与ADAMS圆锥齿轮的建模及仿真
15.
A unified model was established for spur cylindrical gears, helical cylindrical gears, spur bevel gears and helical bevel gears.
建立了直齿圆柱齿轮、齿圆柱齿轮、齿圆锥齿轮、齿圆锥齿轮的统一模型。
16.
marine limpet having a conical shell with an opening at the apex.
在其圆锥状壳的顶端有开口的海生帽贝。
17.
a slender woodwind with a conical bore and a double-reed mouthpiece.
有一个圆锥孔和一个双簧吹口的细的木管乐器。
18.
Inflorescence paniculate, rachis tawny tomentose; female flowers borne on basal part of the inflorescence.
花序圆锥状；花序轴被灰黄色短绵毛；雌花著生于花序轴下部。