1.
Influence Mechanism of Milling Speed on TC4 Titanium Alloy Surface Integrity in High-Speed Milling
高速铣削速度对TC4钛合金表面完整性影响机理
2.
Research on Cutting Force and Surface Roughness of High-speed Ball-end Milling;
球头铣刀高速铣削力及加工表面粗糙度的研究
3.
Surface Roughness Simulation of High-speed Milling of Part with Curved Surface
高速铣削曲面工件的表面粗糙度仿真
4.
The Experimental Study on High-Speed Dry Cutting Based on the Temperature Signals
基于温度信号的高速干铣削试验研究
5.
Modeling Methodology of Milling Deflection and Flexible Milling Force for Tooth Profile of Low-rigidity Cycloid Gear in High Speed Milling
低刚度摆线轮缘高速铣削变形与铣削力建模方法
6.
Influence of Scallop Height by High-speed Milling on Machined Surface Roughness
高速铣削残留高度对加工表面粗糙度的影响
7.
Experimental Study on Surface Roughness of HSM Hardened Steel
高速铣削淬硬钢表面粗糙度的试验研究
8.
The Influence Analysis on Micro Orthogonal Turn-Milling Cutting Speed to Chip Formation;
微小型正交车铣切削速度对切屑变形影响分析
9.
Study on the High-speed Milling Process for the Weak Rigidity Workpieces of Anti-rust Aluminum Alloy
防锈铝合金弱刚度复杂构件高速铣削工艺研究
10.
Experimental Research on Roughness of Complex Surface while High-speed Milling P20 Die Steel
高速铣削P20模具钢复杂曲面粗糙度试验研究
11.
Optimization of Off-Line Feedrate Based on Simulation of Milling Forces
基于铣削力仿真的离线进给速度优化技术
12.
Experimental Study on High Speed Milling Low-rigidity Structure Part of Aluminium Alloy
铝质弱刚度结构件的高速铣削试验研究
13.
Research on Cutting Temperature of End Mill in High-speed Dry Cutting Based on Finite Element Simulation
基于有限元仿真的高速干式切削立铣刀切削温度研究
14.
Study on Effect of Milling Parameters on Milling Force in High-speeding Milling of LF21 Aluminum Alloy
高速铣削LF21铝合金铣削参数对铣削力影响规律的研究
15.
Milling Force Modeling, Simulation and Experimental Study of High Speed Milling;
高速铣削过程铣削力建模与仿真及实验研究
16.
Study on the Machining Mechanism and Parameters Optimization during High Speed Milling of Titanium Alloys
钛合金高速铣削加工机理及铣削参数优化研究
17.
Research on TC17 Titanium Alloy Surface Roughness and Parameters Sensitivity in High Speed Milling Process
TC17钛合金高速铣削表面粗糙度及参数灵敏度研究
18.
Special ultra fine sub micron grade for high speed milling especially for mould making.
特别适合高速铣削的晶粒度为超细的牌号，特别适合模具制造。