1.
Performances of KM Spindle /Toolholder Connection System and Numerical Simulation in High Speed Machining
高速加工用KM刀柄/主轴的联结特性及数值模拟
2.
Design of High Speed Motorized Spindle and the Analysis of Joining Performances for Toolholder/Spindle Interfaces
高速电主轴设计及主轴/刀柄接口联接特性分析
3.
Fatigue Analysis and Calculation of HSK Spindle/Toolholder Interface
HSK主轴/刀柄联接锥面的疲劳寿命分析与计算
4.
FEA of Joint Performances of 7:24 Tapered Tool-holder/Spindle on NC Machine
数控机床7:24锥度刀柄主轴连接性能的有限元分析
5.
Tool shanks and draw-in must have a central through bore.
刀柄和引入轴必带一个穿过钻孔的中心点。
6.
Blade-to-handle ratio. Does the blade look proportional to the handle?
刀与刀柄的比例－刀与刀柄成比例吗？
7.
As the crankshaft rotates, the crankpin swings in a circle around the shaft.
随着曲轴的转动，曲柄销绕主轴作圆周摆动。
8.
The main horizontal bar on a plow to which the share, colter, and handles are attached.
车辕、犁柄犁上主要的横棍，用以固定犁铧、犁刀和柄
9.
cut-throat razor
ph.1. 直柄剃刀,开式剃刀
10.
Analysis to Connecting Shaft Fracture between Motor Reducer and Main Bearing of Cutting Disc of a Shield
盾构电机减速器与刀盘主轴承连接轴断裂分析
11.
"because an eccentric can be attached anywhere along a shaft, it is unnecessary to form any part of the shaft into a crank."
由于偏心轮可装于轴的任何部位,不必把主轴作成曲柄。
12.
A shaft that turns or is turned by a crank.
机轴用曲柄来转动的轴
13.
Blade and handle are the component parts of a knife.
刀身和刀柄是一把刀的组成部分。
14.
The method of changing main-spindle is used in CNC router and automatic tools changer with tools magazine is used in C NC processing center.
数控镂铣机采用更换主轴头换刀方式;而数控加工中心采用带刀库的自动换刀系统进行换刀。
15.
Driving power for the cutting tool comes from the rotation of the spindle, which is a hollow shaft that rotates in bearings.
刀具的驱动力来自主轴的旋转，主轴则是一根在轴承中旋转的空心轴。
16.
Install axle shaft bearing with Installer 6436 and Handle C–417Ensure that the part number on the bearing is against the installer.
用安装工具6436和柄C–4171安装主动轴轴承。要保证轴承部件号码对着安装工具。
17.
"Roman swords had a short, flat Blade and a hilt distinct from the Blade."
罗马军刀刀刃短而平,刀柄明显区别于刀刃。
18.
tanners' knife, with or without handles
跷皮刀,不论是否有手柄