说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 高频引弧器
1.
The Study of HF Arc Starter Compatible with Inverters for Arc Welding
与弧焊逆变器兼容的高频引弧器的研究
2.
DESIGN OF ARC TRANSDUCER ARRAY WITH HEART-SHAPED DIRECTIVITY
高频心形指向性圆弧换能器阵的研制
3.
Design high frequency to increase voitage and pulse heat to strike arc,so with fine ability to start arc. so with fine ability to start arc.Welding current is sufficient.
采用高频增压引弧及脉冲热引弧设计,起弧性能极佳,焊流电流充足,卓越的性能价格比。
4.
Experimental Study on a New Engineering Ceramics Processing Method by Micro-explosion of the High Frequency Arc Ignition
高频引弧微爆炸加工工程陶瓷新方法试验研究
5.
Research on the inverter air plasma cutting machine of non-HF contact pilot arc
非高频引弧逆变空气等离子切割机的研究
6.
Study on Principle and Technical Characteristics of High Frequency Pulsed Arc Welding Inverter
高频脉冲弧焊逆变器原理与工艺性能的研究
7.
The application of high voltage frequency inverter in dust fan of electric arc furnace at steel plant
高压变频调速器在炼钢厂电弧炉除尘风机上的应用
8.
Application of HV-Inverter on Draft Fan in Power Plant
高压变频器在热电厂引风机的成功应用
9.
Reconstruction of High Voltage Frequency Converter of Boiler Induced Draft Fan in Power Plant
高压变频器在电厂锅炉引风机上的改造实践
10.
VHF and UHF direction finder
甚高频与超高频测向器
11.
Secondary Arc Spectrum Characteristics on EHV Transmission Lines
超高压输电线路的潜供电弧频谱特性
12.
TIG arc behavior of ultrafast-convert high-frequency variable-polarity square wave
超快变换高频变极性方波TIG电弧行为
13.
high-frequency and modulation frequency signal generator
高频调频信号发生器
14.
The extinguish of arc of single-phase grounding fault is analyzed with high frequency theory and fundamental frequency theory.
本文分析了小电流接地系统弧光接地过电压的基本原理及高频熄弧理论和工频熄弧理论。
15.
The Research of High Voltage Ignite Digital Welding Machine for TIG;
数字化高压引弧式TIG焊机的研制
16.
Simultaneously we append a high frequency amplifier in the high frequency sector, in order to recover the reduction of the gain in the new system.
同时,在改进后雷达的高频部分增加高频放大器,以抵消天线改进后引起的增益下降。
17.
Computation of Quality Factors When Two Transformer Models Are lntroduced into High Frequency Tuning Loop
高频调谐回路引入两种变压器模型后的品质因数计算
18.
This product is used for connecting motor and frequency converter of some other places where higher shielding performance is required.
本产品与变频器连接的电机引线或其它有较高屏蔽要求场合使用。