1.
standing piston travel
停车时的制动缸活塞行程
2.
oversquare engine
超方发动机(气缸直径大于活塞行程的发动机)
3.
displacement of compressor
压缩机活塞的行程容积
4.
Abstract: Valve may collide with piston wnen diesel runs, so we calculate dimensional train.
针对发动机运行过程中气门碰活塞的问题，要进行尺寸链的计算。
5.
"As lower hood lines and over square engines became popular, the semi-slipper and full-slipper pistons came into use. "
由于低发动机罩和短行程发动机的进一步普及,半围延裙活塞和滑裙式活塞开始使用。
6.
"In the two-cycle engine, the piston acts as a valve, clearing valve ports in the cylinder wall as it nears BDC."
在二行程发动机中,活塞起到阀门的作用,当活塞接近下止点时,使气缸壁上的进排气口打开。
7.
"One reason for the slipper piston is that, on the short-stroke, over square engine, the piston skirt had to be cut away to make room for the counterweights on the crankshaft. "
使用滑裙活塞的原因是:短行程发动机需除去部分活塞裙部,从而为曲轴的平衡重让出空间。
8.
"In other words, the piston completes a stroke each time it changes its direction of motion,"
换句话说,活塞每完成一个行程,就改变一次其运动的方向。
9.
PISTON DISPLACEMENTPiston displacement isthe volume that the piston displaces as it moves from BDCto TDC.
活塞排量:活塞排量是当活塞从下止点运行到上止点时,活塞排出气体的体积。
10.
The stroke is double the throw, and the strokelength is the distance that the piston travels from TDC to BDC and vice versa.
一个冲程等于两个摆幅的行程是活塞从上止点运动到下止点的距离，反之亦然。
11.
The Bore is the diameter of the cylinder. The stroke is the distance the piston travels from BDC (Bottom dead center) to TDC(top dead center). The Bore is always mentioned first.
内径指的是气缸的直径;行程是活塞从下止点运行到上止点的距离。表述时,内径总是写在前面。
12.
An inward stroke, especially a piston stroke moving away from the crankshaft.
内冲程向内的冲程，尤指从曲轴移回的活塞冲程
13.
positioning of piston operated value
控制活塞操纵阀的开启程度
14.
The piston is an important part of a four-stroke cycle engine.
活塞是四冲程发动机的重要部件。
15.
Development of Piston Heating-power Coupling Analysis Procedure Based on APDL
基于APDL的活塞热力耦合程序开发
16.
Numerical simulation analysis of preforging process of steel piston
锻钢活塞预成形过程的数值模拟分析
17.
SIMULATION OF EXPANSION PROCESS IN CO_2 ROLLING PISTON EXPANDER
CO_2滚动活塞膨胀机膨胀过程模拟计算
18.
Simulation of Two Stroke HCCI Free Piston Linear Alternator
两冲程HCCI自由活塞式内燃发电机仿真