1.
Wrought aluminium and aluminium alloy extruded profiles--Tolerances on dimensions and shape
GB/T14846-1993铝及铝合金挤压型材尺寸偏差
2.
Influence of Measurement Deviation Upon Motion Error for Four-Bar Linkage Beating-Up Mechanism
四连杆打纬机构尺寸偏差对运动误差的影响
3.
Die forgings of aluminium and aluminium alloy--Dimensional tolerance and machining allowance
GB/T8545-1987铝及铝合金模锻件的尺寸偏差及加工余量
4.
Measuring method for size and deviation of vitrified clay pipe
GB/T2837-1998陶管尺寸及偏差测量方法
5.
" Hot-rolled beam steel-Dimensions, shape, weight and tolerances"
GB/T706-1988热轧工字钢尺寸、外形、重量及允许偏差
6.
" Hot-rolled channel steel-Dimensions, shape, weight and tolerances"
GB/T707-1988热轧槽钢尺寸、外形、重量及允许偏差
7.
Wrought aluminium and aluminium alloy sheets and strips--Tolerances on form and dimensions
GB/T3194-1998铝及铝合金板、带材的尺寸允许偏差
8.
" Hot-rolled equal--leg angle steel--Dimensions, shape, weight and tolerances"
GB/T9787-1988热轧等边角钢尺寸、外形、重量及允许偏差
9.
" Dimensions,shape,weight and tolerances for forged flats"
GB/T16761-1997锻制扁钢尺寸、外形、重量及允许偏差
10.
" Dimensions, shape, weight and tolerances for hot-rolled flats"
GB/T704-1988热轧扁钢尺寸、外形、重量及允许偏差
11.
Dimenisions shape weight and tolerances for hot-rolled wire rods
GB/T14981-1994热轧盘条尺寸、外形、重量及允许偏差
12.
" Dimensions, shape, weight and tolerances for hot-rolled L-sectional steel"
GB/T9946-1988热轧L型钢尺寸、外形、重量及允许偏差
13.
Study on Tolerance Dimension Excursion Control During Machining;
关于加工中公差尺寸偏移控制的研究与探讨
14.
Correction of Calculative Deviation in Statistical Tolerance Convolution Algorithm
非线性尺寸链卷积算法的计算偏差修正
15.
" Dimensions,shape and tolerances for cold-rolled steel strips with a width less than 600mm"
GB/T15391-1994宽度小于600mm冷轧钢带的尺寸、外形及允许偏差
16.
" Forged round and square steels--Dimension, shape, weight and tolerance"
GB/T908-1987锻制圆钢和方钢尺寸、外形、重量及允许偏差
17.
" Dimensions, shape, weight and tolerances for cold-rolled plates and sheets"
GB/T708-1988冷轧钢板和钢带的尺寸、外形、重量及允许偏差
18.
" Dimensions, shape, weight and tolerances for hot-rolled plates and sheets"
GB/T709-1988热轧钢板和钢带的尺寸、外形、重量及允许偏差