1.
d range of spindle speeds
主轴转速级数和范围
2.
H~∞ robust control for principal axis speed of variable vector propeller of submersible vehicle
潜器全方位推进器主轴转速H~∞鲁棒控制
3.
Design a robust H_∞ controller for principal axis speed of variable vector propeller
潜器全方位推进器主轴转速鲁棒H_∞控制器设计
4.
capstan tachogenerator signal
主导轴转速传感信号
5.
Modeling and Simulation of Tilting Principal Axis Five-axis High-speed Milling Machine
主轴可转位五轴高速铣床的建模与动态仿真
6.
"Rotary motion of the transmission main shaft carries through the propeller shaft to the differential, causing the rear wheels to rotate."
变速器主轴的旋转运动通过传动轴传递到差速器上,使后车轮转动。
7.
rotating rapidly about an axis.
围绕一个主轴急速旋转的。
8.
Monitor and Control for Revolution Speed of Spindle Motor Based on PMC Windows Function
基于PMC窗口功能的主轴电机转速监控
9.
Analysis on Spindle Rotor Critical Speed Based on Transfer Matrix Method
基于传递矩阵法主轴转子临界转速分析
10.
"The overdrive is a mechanism interposed between the transmission and propeller shaft to permit the propeller shaft to turn faster than, or overdrive, the transmission main shaft."
超速档是装在变速箱和传动轴之间的一套机械装置,使传动轴比变速器主轴转的更快。
11.
Research on Optimize Design of Main Axle of High Rotational Speed and High Precision Machine Tool;
高转速高精度机床主轴优化设计的研究
12.
This bearing limit rotational speed is low, (therefore mainly applies on the mill calls rolling mill bearing).
该轴承极限转速较低，主要应用于轧钢机上（故称轧机轴承）。
13.
Study on Dynamic Characteristics of Ball Bearing-Rotor System in Ultra High Speed Spindles;
超高速电主轴球轴承—转子系统动力学性能的研究
14.
Spindle feeds and speeds are controlled by selector levers which engage the proper gears in the drill head.
主轴的进能量和转速是通过选速杆使主轴箱中的适当齿轮相啮合而控制的。
15.
The fastest rotated speed of principal axis motor of optical disc driver has reached about 12000rpm nowadays.
现今光盘驱动器主轴马达的最高转速约为每分钟12000转。
16.
Gyroscope: A mechanical gyroscope consists of a rapidly spinning wheel set in a framework that permits it to tilt freely in any direction or to rotate about any axis.
陀螺仪:主要组成部分是安装在框架内能绕任意轴高速旋转的转子。
17.
For a rigid body rotating about a principal axis, the angular acceleration is related to torque by T =Ia.
对于绕主轴转动的刚体来说，角加速度与转矩的关系是T＝Ia。
18.
This second shaft is known as the cam shaft, and drives the picking and on the cam shaft.
这第二根轴的转速为主轴的1/2,被称之为凸轮轴,它驱动投梭机构和开口机构。