1.
Effect of different amount of Qu on fusel oils in Sauce-flavor liquor
不同加曲量对酱香型白酒中杂油醇影响探讨
2.
For instance, when using flat-bottomed cutter to process curved surface, negative margin cannot be offered.
如在使用平底刀做曲面加工时,不能给负余量。
3.
Analysis and measurement of error source of curved surfaces machined on CNC milling machine and grey identification
数控铣床曲面加工误差源分析测量与灰色识别
4.
Influences of Additional Press Bar Curvilinear Drafting Top Pin on Yarn Quality
附加压力棒曲线牵伸上销对成纱质量的影响
5.
Five-axis Tool Orientation Optimization Based on Kinematical Method
自由曲面五轴加工刀轴矢量的运动学优化方法
6.
The efficacy of reinforcing sclerotherapy after esophageal variceal ligation on recurrence of varix in patients with liver cirrhosis
小剂量硬化剂加固对食管静脉曲张术后的影响
7.
Effects of heating processing method on AFB1 content in TCM cut crude drug
加热炮制对中药饮片黄曲霉毒素B1含量的影响
8.
Read horizontally to flow rate curve and vertically downward to flow rate gpm.
读出水平线上的流量曲线和垂直线下方的的流量（加仑/分钟）。
9.
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
结果表明,复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
10.
The volume can be confirmed by curve of setting time and electrokinetic potential relation.
外加剂的掺量可由凝结时间一电动电位曲线确定。
11.
With the increase of graphite content, the bending frature morphology changes gradually from dimple to cleavage.
随石墨含量的增加，材料的弯曲断口由韧窝向解理，沿晶断口过渡。
12.
Control Method of Material Removal in Digitized MAF for Mold & Die Surface
模具曲面数字化磁力研磨加工中研磨量的控制方法
13.
Comparison of Penetration and Obturation Density Using Nickel-titanium and Stainless Steel Finger Spreader in Curved Canals;
侧方加压器进入弯曲根管的深度及根充质量的实验研究
14.
Influence of Superposition for Multi-Flow With Different Rates and Multi-Shut-in to Well Test Curves
多次开关井变产量叠加分析对试井解释曲线的影响
15.
Effect of addition of uncooked wheat starter on brewing and flavor of rice wine
不同添加量的生麦曲对黄酒酿造和风味影响的研究
16.
Quality comparison of ellipsoid surface machined by equal-distance and bi-equal-distance method
椭球曲面的等间距和双向等间距加工质量的比较
17.
Stress-strain relationship and modulus of elasticity of 16Mn steel under loading and constant temperature
Q345(16Mn)钢在恒温加载条件下的应力-应变曲线和弹性模量
18.
The Effect of the Number of Screws on Strain and Bending Stiffness of the Dynamic Compression Plate Strain
螺钉数量对动力加压钢板应变和弯曲刚度的影响