1.
Difference of the Intension of Incision between Corneal Tunnel Incision and Sclera Tunnel Incision and the Study in Histopathology;
巩膜隧道切口与角膜隧道切口强度比较及组织病理学研究
2.
Conclusion Prolene mesh was effective in treating incisional hernia and easy to process.
结论应用聚丙烯网片修补腹壁切口疝简便易行，可以降低切口缝合张力，加强腹壁强度。
3.
Their results showed a more rapid rate of increase in the dynamic SIF for blunt than for sharp notches.
它们的结果表明：钝切口比尖锐切口的动态应力强度因子增长率更快。
4.
The Formulae and Finite Element Methob of Determining the stress Intensise Factors for the Heel Notch of the Gravity Dam
确定重力坝坝踵切口应力强度因子的公式及其有限单元法
5.
Research on Boundary Element Analysis of Coating-structures and Interfacial Strength of V-notched Structures;
涂层结构和V形切口界面强度的边界元法分析研究
6.
Photoelastic Investigation and Numerical Analysis of the Determination of SIF for "V" notch;
确定V形切口的应力强度因子的光弹性实验和数值方法的研究
7.
Evaluation of Adhesion Strength of High-Strength Coating by Symmetrical-Incision Tensile Testing and Analysis of Its Plane Stress bv Finite Element Method
对称切口拉伸法评价高强度涂层及平面应力有限元分析
8.
testing methods for shear strength of plastics by punch tool
塑料剪切强度试验方法
9.
uniform strain shearing strengh tester
等应变剪切强度测试仪
10.
"Maximum shear Strength 63Kg/mm2(90,000psi) maximum (based on 75% yield) "
剪切强度最大63Kg/mm2(90000psi)(为屈服强度的75%)
11.
Testing Method for Tensile and Shear Strength of High Strength Photosensitive Glue
高强度光敏胶拉伸剪切强度测试方法
12.
testing method for apparent interlaminar shear strength of carbon fiber reinforced plastics by three point loading method
纤维增强塑料的短梁层间切变强度法
13.
NOTCHED TENSILE PROPERTY OF SHORT GLASS FIBER REINFORCED PA6
短切玻纤增强尼龙6的缺口拉伸性能
14.
MICROSTRUCTURE AND HARDNESS OF ADIABATIC SHEAR BANDS IN HIGH STRENGTH STEELS
高强度钢中绝热剪切带的组织和硬度
15.
Numerical Simulation of Precutting′s Angle and Height of Chimney Blasting
烟囱爆破切口角度高度数值模拟研究
16.
An Experimental Study of the Adiabatic Shear Behavior in Orthogonal Cutting of High Strength Steel
正交切削高强度钢绝热剪切行为的实验研究
17.
Influence of diamond concentration,grit size and hardness on the performance of diamond saw blade
金刚石浓度、粒度和强度对锯片切割性能的影响
18.
The relationships between the cutting speed and a incised workpiece of intension, thickness are analyzed.
通过试验，分析了被切割工件强度和厚度与切割速度之间的关系。