1.
Moulding machine: Squeeze moulding machine, Multisqueeze head moulding machine, Machanical moulding line, Air shock moulding line, Air shock and press moulding machine.
造型设备：各类震压式造型机，气动多触头造型机，机械化造型线，气冲造型线，静压造型线。
2.
Static finite element analysis on cast case of large-scale centrifugal compressor
大型离心式压缩机铸造机壳的静态有限元分析
3.
Non-linear Pressure Condition in Filling of Aluminum Alloy Wheel in Low Pressure Die Casting
铝合金轮毂低压铸造充型非线性压力条件
4.
Design Problems of Vertical Parting Flaskless Shoot Squeeze Molding Line
垂直分型无箱射压造型线设计问题探讨
5.
Improving Efficiency of Axial-flow Compressor with the Application of Non-axisymmetric Stator Hub
利用静子非轴对称轮毂造型提高轴流压缩机效率
6.
New Optimal Nonlinear PI Voltage Controller for SVC
静止无功补偿器的新型最优非线性比例积分电压控制
7.
Flowing freely curve shape,delineate the sport and the metre that calmness art possess singly.
流畅的曲线造型,勾勒出动与静之间艺术独有的韵律.
8.
Three-Dimensional Parametric Modeling and Statics Analysis of Hoop Truss Deployable Satellite Antenna;
环形桁架卫星天线的三维参数化造型及静力学分析
9.
Dynamic-static Pressure bearings for cement mill and static Pressure reformation to its oil supplying system
水泥磨动静压轴承及其供油系统的静压改造
10.
The Feasibility Analysis of Liqun I Loop Which Steps up from 35kV into Compacted 110kV Transmission Line
李群Ⅰ回35kV线路改造升压为紧凑型110kV线路的可行性分析
11.
Geometry of Arcs and Their Evolution Profile of Twin Screw Compressors;
双螺杆压缩机转子圆弧及圆弧包络线型线的几何构造
12.
The Analysis of Cantilever Strength of ZYB600F Hydraulic Static Pile Engine Base on Cosmos;
ZYB600F型液压静力压桩机悬臂强度的分析
13.
produces a high voltage by building up a charge of static electricity.
通过产生静位觉电荷制造高压。
14.
Hydraulic system for large bearing ring forging line as well as the proportion technique adopted
大型轴承环锻造生产线液压系统及比例技术的应用
15.
The Modeling Metho d for Axia-flow Compressor Blade with Elementary Stage by Modifying the Pre-edge or Post-edge Based on Bizer Curves
基于Bizer曲线前后缘修正的轴流压缩机基元级叶片造型方法
16.
The Real-time Discrimination of the Main-bus Reactive Power-voltage Static Characteristics;
母线无功——电压静态特性的实时辨识
17.
Simulation of Strain-strain Curve for EPE Static Compression
EPE静态压缩应力-应变曲线模拟
18.
Fixture Modification for Linear Cutting Dovetail Groove for Stationary Blade Attachment
线切割燕尾形静叶榫槽工艺装备改造