1.
fine ceramics(advanced ceramics, advanced technical ceramics)-test method for tensile strength of monolithic ceramics at room and elevated temperature
细陶瓷-单块陶瓷常温、高温抗拉强度试验方法
2.
Experiment on tensile and shear strength of front fillet welded joint post-high-temperatures
高温后正面角焊缝抗拉剪切强度的试验
3.
steel has great tensile strength
钢有极高的抗拉强度
4.
The heat treatment improves the tensile strength.
热处理能提高抗拉强度。
5.
Tensile Strength of C/Al Composites at High Temprature
碳(石墨)/铝复合材料的高温拉伸强度
6.
"Carbon steel has high and low temperature strength, is very tough and has excellent fatigue strength."
碳钢具有高温和低温强度,具有很高的韧度和优异的抗疲劳强度。
7.
Mild steel has a high tensile strength, this being 200 times that of concrete.
低碳钢具有很高的抗拉强度，大约是混凝土的抗拉强度的200倍。
8.
They are made up of wire that's high tensile steel.
它们是由高抗拉强度的钢丝组成的。
9.
The results of the tensile test indicate that the composite exhibit relatively high strength both at room temperature and high temperature.
拉伸试验结果表明,该种复合材料具有较高的室温和高温拉伸强度。
10.
The modified gelatin binder not only remains long-term liquid at room tempera ture, but also the tensile strength of core sand prepared from the modified gelat in increased by1～2 times over the unmodified gelatin.
经过改性的动物胶粘结剂不仅在室温下能保持液体，而且，它的抗拉强度比未改性的提高1～倍。
11.
Effect of Stand-off Height on Microstructure and Tensile Strength of Solder Joints
焊点高度对焊点微观组织和抗拉强度的影响
12.
EXPERIMENTAL STUDY ON THE COMPRESSIVE STRENGTH OF PLAIN HIGH-PERFORMANCE CONCRETE AFTER HIGH TEMPERATURES
高温后高性能混凝土抗压强度试验研究
13.
The variation of ultimate tensile strength with length for amosite crocidolite, chrysotile is shown in Table 2.10.
铁石棉，青石棉和温石棉的极限抗拉强度随长度的变化情况见表2．10．
14.
Constitutive equations of high strength aluminum alloy sheet 7B04-T6 under warm tension
高强度铝合金7B04-T6板材温拉伸本构方程
15.
Establisllment of Relation between Cubic Strength and Split Strength about High-Strength Concrete;
高强混凝土的研制及其抗压抗拉强度关系的建立
16.
Test method for modulus of rupture of refractory products at elevated temperatures
GB/T3002-1982耐火制品高温抗折强度试验方法
17.
Test method for modulus of rupture of refractories containing carbon at elevated temperatures
GB/T13243-1991含碳耐火材料高温抗折强度试验方法
18.
Purpose: The equipment is used for mensurating modulus of rupture of refractory products at high temperatures.
该设备用于耐火材料的高温抗折强度的测量。