1.
A bimolecular decay is used to explain the dependence of dynamics of the Kerr signal on the incident light intensity.
一个双激发子弛豫机制被用来解释克尔信号动力学特性对入射光强度的依赖性。
2.
Incident Radiance Reuse Filter and Improvement of Radiance Estimation;
入射光复用滤波和光辐射强度估计的改进
3.
The molecular extinction coefficient is equal to the ration of the log of the intensity of the incident and emergent light.
分子的消光系数等于入极大时的入射光和透射光强度比的对数。
4.
The molecular extinction coefficient is equal to the ratio of the log of the intensity of the incident and emergent light.
分子的消光系数等于入射光和透射光强度对数的比。
5.
The Optical Sphere which Can Bend Every Incident Ray through 180°
使入射光线偏转180度的光学介质球
6.
measuring the intensity of radiation (especially of the sun's rays).
测量放射物的强度（尤其是太阳光线）。
7.
an instrument for measuring the intensity of radiation (usually by the photochemical effect).
通过光化学作用测量射线强度的装置。
8.
STUDY OF THE EFFECTS OF THE LIGHT INTENSITY AND TEMPERATURE ON THE FREQUENCY OF THE Rb MASER
铷激射器频率的光强和温度效应研究
9.
Enhancement of fluorescence of terbium and transferrin-bound diterbium by HEPES
HEPES增强Tb~(3+)和Tb_2Tf的荧光发射峰强度(英文)
10.
spectral radiation exitance
光谱辐（射）出（射）度
11.
The results show that the unequal width element CLA is able to improve the homogeneity along the focus line for an incident laser with both Gaussian and uniform distribution.
结果表明采用不等宽单元技术能大大改善入射光场为高斯分布型的焦线强度分布均匀性。
12.
Research on the Reflective Intensity Modulated Fiber Optic Accelerometer;
反射式光强调制型光纤加速度计的设计
13.
Analysis on Intensity Modulation Characteristics for Optic Fiber Pair of Reflective Fiber Optic Sensor
反射式光纤传感器光纤对强度调制特性分析
14.
Research of Scattering Intensity with Spherical Particles in Laser Cladding
激光熔覆中球形粒子对激光散射强度的研究
15.
Low-angle winter sunlight penetration can give rise to glare.
冬季小入射角阳光的透射可以增加室内亮度。
16.
Test Attempt to Shear Strength of in Terface for Embedded Optical Fiber Sensors
埋入式光纤传感器界面剪切强度实验
17.
Analysis of the incident angle's nonlinear disturbing effects on the transmitted light intensity of Glan-Taylor prisms
入射角对格兰-泰勒棱镜透射光强的非线性扰动分析
18.
For example,at 20 degree for high-gloss surfaces and 85 degree for low-gloss surfaces .All readings are compared against that obtained from a standard surface and the amount of floss derived.
例如，光泽高的表面用20度；光泽低的则用85度。反射光的强度和标准比较后，得光泽度。