1.
The Large Precast Components Conveying & Installational Construction Technique on Water;
大型预制构件出运及水上安装施工技术
2.
Can be installed vertically (flow up or flow down) or horizontally.
可以垂直（流向朝上或流向朝下）安装或水平安装。
3.
Regulator may be installed vertically or horizontally (upright or inverted).
调节阀可以垂直安装或水平安装（朝上或超下）。
4.
Install the valve into the opening provided and marked for this purpose in the water heater
在热水器上用于安装安全阀的接口处安装安全阀
5.
Install a vacuum relief anti-siphon device in the cold water inlet line.
在冷水进水管上安装一个反虹吸的真空安全法。
6.
wash-basin (usually fixed to a wall and fitted with taps)
洗脸池（通常安装在墙上的,有水龙头）.
7.
Install a shutoff valve in the cold water inlet. Install a listed temperature-pressure relief valve in the remaining fitting.
在冷水进水管上安装一个关断阀。在剩下的螺纹接头上安装额定温度/水压的安全阀。
8.
Install a 125 PSI pressure relief valve in the cold water supply line.
在冷水供应管道上安装一个125PSI的减压安全阀。
9.
The fan can be mounted in ways hanging on the ceiling or fixing on the wall. Upon request of users.
本风机可采用悬挂吊装式安装或支架承托安装，上水泥预埋安装；并可根据用户要求生产。
10.
Install a listed temperature-pressure relief valve in the opening on the side of the heater.
在热水器侧面的开口位置上安装额定温度/水压的安全阀。
11.
Such mechanisms were soon built into dams to harness vast amounts of electricity.
不久就把这种机器安装在水坝上，用来大量发电。
12.
A tempering valve can be installed in the domestic hot water line as shown in Figure 2.
建议在家庭热水管线上如图2所示安装调节阀。
13.
An anti-scald device is recommended in the hot water supply line to reduce the risk of scald injury.
建议在热水供应管道上安装防烫装置，减少被烫伤的危险。
14.
Install a listed temperature-pressure relieve valve in the remaining fitting.
在剩下的螺纹接头上安装额定温度/水压的安全阀。
15.
Install a diaphragm-type expansion tank that is suitable for potable water on the cold water supply line.
在冷水供应管道上安装一个适用于饮用水的隔膜型膨胀罐。
16.
Lower the slip joint and fix its top connector into the diverter.
下放伸缩隔水管，将伸缩隔水管顶部接头安装到转喷器壳体上。
17.
To equip(a waterway) with locks.
（在水道上）装上水闸
18.
The flame arrester can be installed horizontally or vertically.
本阻火器可水平安装，也可垂直安装。