1.
FEM Simulation of RR Method Bend-Upset Forging of Heavy Crankshaft;
大型曲轴RR法弯曲镦锻成形有限元模拟
2.
Failure analysis of upset-bending equipment for a heavy crankshaft with continuous grain flow
大型全纤维曲轴TR镦锻装置失效分析
3.
The design of a support with eccentricity for turning high-power 9 cylinders diesel engine crank pin
大型9缸柴油机曲轴连杆轴颈车削偏心扶架设计
4.
Research on the upset forging sunk defects of large full fiber crankshaft's balance block
大型全纤维曲轴平衡块成形塌角问题研究
5.
Finite Element Analysis and Optimization Design on Large-scale Ship Crankshaft Grinding Machine
大型船用曲轴磨床的有限元分析及优化设计
6.
Numerical Simulation and Experiment Study on Forging Technique of Large Marine Assembled Crank of Crankshaft;
船用大型组合式曲轴曲柄锻造工艺的数值模拟及实验研究
7.
Replacing precision-insert main bearings without removing the crankshaft requires about 5 hours. Removing and replacing the crankshaft requires several additional hours.
不拆曲轴更换精密嵌入型主轴承,大约需要5小时,拆卸和更换轴承要额外增加几小时。
8.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的
9.
Analysis on Accident of Main Shaft Bending of HP-IP Rotors in Large Steam Turbine and its Countermeasures
大型汽轮机高中压转子大轴弯曲事故分析及对策
10.
Analysis of TR Upset-Bending Process and Equipment Optimization for Heavy Crankshaft with Continuous Grain Flow
大型全纤维曲轴TR镦锻成形分析及装置结构优化
11.
Propagation of Decentered Twist Anisotropic Gaussian-Schell Model Beam in Turbulent Atmosphere
离轴扭曲各向异性高斯-谢尔模型光束在湍流大气中的传播
12.
Most modern automotive engines have precision-insert-type. main bearings which can be replaced without removing the crankshaft.
大多数现代汽车发动机的主轴承是精密嵌入型,不必拆下曲轴即可更换。
13.
Development of the Recognition System for output Shaft Type of Gasoline Engine Crank;
汽油发动机曲轴输出轴类型识别系统的研制
14.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
15.
Suitable for precisely cleaning of aury-axle &small size fittings.
适用于曲轴及小型零件的高精度清洗。
16.
Stress Analysis of Finite Element to JZH25 Homogenizer Crankshaft Based on ANSYS;
基于ANSYS的JZH25型均质机曲轴的应力分析
17.
The Dynamic Analysis with Fem on the Structure of 4125A Diesel Crankshaft
4125A型柴油机曲轴结构有限元动力分析
18.
Research on a Newly Combinational Tri-turned Crankshaft for Diaphragm Pump
新型组合式隔膜泵用三拐曲轴的研究