1.
Calculation about Reliability of Turn Arm Bearings in cycloid Speed-Reducer
摆线针轮行星传动减速器转臂轴承的可靠性计算
2.
The transmission principle and dynamic analysis of the inner planetary gear reducer with three axies are described in this paper.
本文论述了三轴式内齿行星减速器的传动原理、力学分析，推导出转臂轴承作用力的计算公式。
3.
According to the principle of resistance power and driving power being equal in amounts, the key parameter, the greatest acting force acted on the active tooths by the revolving arm ball bearing of the shock wave instrument is resulted.
根据阻力功和动力功相等的原理,推导出关键参数激波器转臂轴承对活齿的最大作用力.
4.
reverse idler gear shaft bearing
回动空转齿轮轴轴承
5.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
6.
The part of a vertical shaft that turns in a bearing.
轴踵轴承中能旋转的垂直的轴
7.
Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.
大多数轴承都支承径向或轴向负荷的转轴。
8.
tube and ball type steering column
球轴承套管式转向管柱
9.
steering knuckle bearing grease nipple
润滑转向节轴承油嘴
10.
steering worm sector bearing
转向器扇形蜗轮轴承
11.
Install pitman shaft and side cover in the housing.
在机座中安装转向摇臂轴和侧盖。
12.
Precise 3D Modeling of Design of Arm Shaft;
转向摇臂轴的精确三维造型设计应用
13.
Effect of the Axle Box Rotary Arm Positioning Mode on Resilient Nodal Points
轴箱转臂定位方式对弹性节点的影响
14.
The trunnion assembly is supported by air bearings at the end of each arm and is held in position by brake shoes at each bearings.
耳轴组件的支承是每根臂末端的空气轴承，轴承上的闸瓦起定位作用。
15.
In rotating, the shaft splashes oil up into the bearings.
当轴旋转的时候就把油溅入轴承。
16.
Bearings keep the shafts steady.
轴承可以使轴的旋转保持平稳。
17.
Reasons Analysis and Maintenance Measures for the Failture of Converter Trunnion Bearing
转炉耳轴轴承的故障分析和维护措施
18.
"Essentially, the steering gear consists of two parts, a worm on the end of the steering shaft and a pitmanarm shaft on which there is a gear sector, toothed roller, or stud."
转向器基本上由两部分组成:装在转向轴末端的蜗杆和转向摇臂轴。