1.
Before performing this procedure, the worm bearing preload adjustment must be performe
进行本程序之前，必须调节螺杆轴承的预应力。
2.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
3.
Measurement and Study on Screw Torque and Axial Thrust of Twin Screw Pulping Extruder
双螺杆磨浆机螺杆扭矩和轴向推力的测量与研究
4.
a shaft with screw thread (the worm) meshes with a toothed wheel (the worm wheel); changes the direction of the axis of rotary motion.
螺纹杆与齿轮相啮合；改变轴旋转运动的方向。
5.
X axis and Y axis adopt ball spiral rods with excellent precisions and low friction factors.
X.Y轴采用滚珠螺杆传动精度佳，摩擦系数小。
6.
propeller blades that rake backward from the shaft;rake a ship's mast.
从轴心向后倾斜的螺旋桨叶；使船的桅杆倾斜
7.
The adjustment of rotation angle error of power box twin export axles of twin screw extruder
双螺杆挤压机动力箱双输出轴转角误差调整
8.
Finite Element Analysis of Stepped Bearing in ESPCP System;
潜油螺杆泵采油系统中阶梯轴承的有限元分析
9.
The Research of Key Technologies about Axial Bearing Ability in ESPCP System
潜油螺杆泵采油系统轴向承载关键技术研究
10.
Analysis of Mechanics Performance and Life Prediction for Lobe Type Couplings of PDM
螺杆钻具万向轴力学特性分析及寿命预测
11.
Structural analysis and improved design for transmission shaft of screw-drilling device
螺杆钻具传动轴的结构分析与改进设计
12.
Strength Analysis of Pressure and Torsion Combination Loads of Flapper Teeth of LTC
螺杆钻具瓣形万向轴瓣齿压扭组合强度分析
13.
Motion Simulation of ESPCP Special Coupling Based on UG
基于UG的电动潜油螺杆泵专用联轴器运动仿真
14.
Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.
松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。
15.
W is attached to a bar, movable vertically around an axis A and suspended by the helical spring F.
摆锤w装在一根杆上，在轴A周围垂直移动，它由螺旋弹簧F所悬挂。
16.
Re-analysis of the Drive Sleeve Built-in Stem Nut in Multi-turn Electric Actuator
多回转阀门电动装置输出轴内装阀杆螺母结构的再认识
17.
Theoretical Analysis and Experimental Study of Axial Circle Flow in Twin-Screw Extrusion;
双螺杆挤出过程轴向循环流理论分析及实验研究
18.
conveyer screw shaft coupling
输送机螺旋轴联轴节