1.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
2.
Bevel gears: gears which connect two shafts at right angles.
伞齿轮:连接直角相交两轴的齿轮。
3.
A Control System of Two-axis Synchronous Motion Based on Motion Controller;
基于运动卡的两轴同步运动控制系统
4.
Analysis on Critical Technologies for Two-Axis Strap-Down Stabilized Tracing Platform
两轴捷联稳定跟踪平台关键技术分析
5.
Pressure-compensated air bearings are used on both ends of the trunnion axis.
耳轴两端各用一压力补偿空气轴承。
6.
two -joint inboard slip drive shaft
两万向节滑动的传动轴
7.
A pin or gudgeon, especially either of two small cylindrical projections on a cannon forming an axis on which it pivots.
炮耳轴或耳轴，尤指炮两边形成旋转中轴的两个圆柱形小突起
8.
Thus a normal loom has two shafts. The main shaft(crankshaft or top shaft) drives the lay mechanism and is geared to another shaft which operates at half of the speed of the crankshaft.
这样,普通织机应具备两根轴,主轴(曲拐轴或位于上部的轴)驱动筘座并通过齿轮驱动另一根轴。
9.
This means that the crankshaft will make two revolutions for every revolution of the camshaft.
这意味着凸轮轴每旋转一次曲轴将旋转两次。
10.
Experimental Research on Oil-Air Two Phase Lubrication of High Speed Motorized Spindle Rolling Bearing;
高速电主轴滚动轴承油气两相流润滑试验研究
11.
Measures for improving the concentricity of the bearing s minor hole at the two ends;
提高套筒两端轴承档内孔同轴度的措施
12.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
13.
Either extremity of an axis through a sphere.
（轴的）两极穿过一个球体的中轴的两端中的任一端
14.
Two 2-axis, 2-button joysticks on one gameport
一个游戏端口上有两个轴、两个按钮的游戏杆
15.
However, there are two possible axial directions.
不过，沿着轴线也还有两种可能的方向。
16.
contrarotating propeller
同心套轴的两个对转螺旋桨
17.
contra turning propeller
同心套轴的两上对转螺旋桨
18.
a cutting implement having two crossed pivoting blades.
有两个绕公共轴的交叉的刃片的切具。