1.
Harmonic parameter identification of dynamic response in regenerative machining chatter system
再生切削颤振系统动态响应谐参数辨识
2.
Influence of the Orientation of Principal Stiffness Axes on the Harmonic Parameters of Dynamic Response in Mode-Coupled Regenerative Machining System
刚度主轴方位对模态耦合再生切削系统动态响应谐参数的影响
3.
Research on the Nonlinear Dynamics Analysis of Regenerative Tool Chatter
再生型切削颤振的非线性动力学分析
4.
Harmonic Retrieval of the Dynamic Responses of Regenerative Machining System;
再生型切削加工系统动态响应的谐波恢复
5.
The Malfunction of Aqueous Metal-Cutting Fluid and the Designing of Its Regeneration Equipment
水基金属切削液的失效及其再生设备设计
6.
The Analysis and Simulation of NC Regenerative Cutting Chatter System
数控再生型切削颤振系统的分析及仿真
7.
The Character of Corneal Regeneration Nerves after Different Excimer Laser Operation by Confocal Microscopy;
共聚焦显微镜分析不同准分子激光切削法角膜神经纤维再生特点
8.
Study on the Forming Principle of the Cutting Burr in Turning
车削加工中切削毛刺生成机理的研究
9.
generating cutting
滚(齿)切(削)法
10.
Forming Mechanism of Tooth Flank Burr in Cutting Gear
齿轮齿形切削加工中的毛刺生成机理
11.
The Study on the Magnetic Machinable Bioactive Glass-ceramics;
磁性可切削生物活性微晶玻璃的研究
12.
Research on Grey Model of Chip Qualified Rate and Cutting Force of Typical Biomaterials;
典型生物质材料削片合格率灰色模型与切削力研究
13.
Biological Safety Assessment of the Machinable Bioactive Glass-ceramic;
可切削生物活性微晶玻璃的生物安全性评价
14.
working major cutting edge
工作主[副]切削刃
15.
top plate cutting angle
顶片切削角 -锯链
16.
Reaming consists of removing a small amount of metal from a hole already drilled.
绞孔是在一个已钻好孔的基础上再切削少量的金属。
17.
XZ(Red):A rapid metal removel media,heavy than XV,make a smooth surface.
红色)：快速切削的磨块，比XV重，能产生光滑的表面。
18.
A STUDY ON THE LEANED BURR FORMATION IN METAL CUTTING
金属切削中进给方向毛刺的生成机理及其控制