1.
Study on Die of Piston Casting Machine Based on ProCAST
基于ProCAST的活塞浇注机模具研究
2.
Rebuilding a Electric Control System of HLZ10C Piston Casting Machine
HLZ10C型活塞浇注机电气控制系统温控改进设计
3.
concreting boom
浇注混凝土起重机臂
4.
The Application of Tundish Plug Rod Blowing Argon in Vacuum Pouring of Ingot
中间包塞棒吹氩在钢锭真空浇注中的应用
5.
The plunger or piston of a force pump or hydraulic press.
活塞压力泵或水压机内的柱塞或活塞
6.
It's mainly used in ladle backing layer and tundish backing layer.
自流浇注料还可采用机械化施工。
7.
Optimization of feed system and design of injection mould for automotive engine cover
汽车发动机罩盖浇注系统优化与注射模设计
8.
THE FIX FOR THE TRANSVERSE DIAMETER OF DIFFERENT INJECTION MOLD'S SPRUE BUSH
不同注塑机注塑模浇口套端面直径的确定
9.
Piston Oscillation Characteristics of Single Piston Hydraulic Free-Piston Engines
单活塞液压自由活塞发动机活塞振动特性研究
10.
Technology for Long Life of Tundish and Non-stopper Steel Stream Protection of Billet Continuous Casting in ANYANG Iron & Steel Group Co. LTD;
安钢小方坯连铸中间包长寿及无塞棒控流保护浇注工艺研究
11.
Others: Numerical control pouring machine, Gravity die casting machine.
其它设备：数控浇注机，金属型重力铸造型机等。
12.
The steamroller levelled off the gravel roadbed and then the concrete was poured.
蒸汽压路机压平碎石路基，然后浇注混凝土。
13.
Study on effect of organic silicon resin on capability of epoxy resin cast
有机硅树脂对环氧树脂浇注体性能的影响
14.
Study on Large Volume Poured Cement Based Low and Intermediate Level Radioactive Waste and Mechanism of Cs Solidified;
中低放废液大体积浇注水泥固化及铯固化机理
15.
Design and Optimize the Running System of Cylinder Block and Numerical Simulation
发动机缸体浇注系统的优化设计与数值模拟
16.
Optimization of Casting Process for Manufacturing Babbitt Metal Bearing Bushings Used in Diesel Engines and Experiment Verification
柴油机轴瓦巴氏合金浇注工艺优化及试验验证
17.
a piston syringe that is fitted with a hypodermic needle for giving injections.
带有皮下注射器针头进行注射的注射器活塞。
18.
engine ,piston, for aircraft
活塞发动机,航空用