1.
Experimental Study on Strength of Air-entrained Concrete under Multiaxial Loads after Freeze-thaw Cycles;
引气混凝土冻融循环后多轴强度的试验研究
2.
Study on the Strength of Air-entraining Concrete under Multiaxial Stress States after Freeze-thaw Cycling;
冻融条件下引气混凝土多轴强度的试验研究
3.
Research on Multi-axial Strength and Deformation Characteristics of Lightweight Aggregate Concrete;
轻骨料混凝土多轴强度与变形性能研究
4.
Study on the Strength and Deformation of Concrete under Multiaxial Stress after High-temperature or Freeze-thaw Cycling;
高温及冻融循环后混凝土多轴强度和变形试验研究
5.
Study on the Strength of Wet-screened Mass Concrete under Multiaxial Stress States after Freeze-thaw Cycles;
冻融条件下湿筛大骨料混凝土多轴强度的试验研究
6.
Study on the Strength of Wet-screened Aggregate Concrete under Multiaxial Stress States after Freeze-thaw Cycles in Seawater;
海水中冻融循环后湿筛混凝土多轴强度的试验研究
7.
Experimental Study on the Strength of Wet-screened Large Aggregate Concrete under Multiaxial Loads after Freeze-thaw Cycles
湿筛大骨料混凝土冻融循环后多轴强度的试验研究
8.
Research on the Strength and Life of the Engine Intermediate Case under Multiaxial Loads;
多轴载荷下发动机中介机匣强度与寿命研究
9.
Multi-body dynamics and finite element method co-simulation for crankshaft dynamical strength analysis
曲轴强度多体动力学与有限元子模型法仿真
10.
Multi-Axial Fatigue Strength Analysis of Wheel Based on FEA
基于有限元仿真车轮多轴疲劳强度分析
11.
Optimization Design of Bearing for Internal Combustion Engine Considering Crankshaft Strength;
计及曲轴强度的内燃机轴承优化设计
12.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
13.
A dynamic strength analysis of diesel crankshaft based on nonlinear multi-body dynamics and finite element method
基于非线性多体动力学和有限元法的柴油机曲轴动态强度分析
14.
Coupling Research on Tribology, Stiffness and Strength of Crankshaft-bearing System;
曲轴—轴承系统摩擦学、刚度和强度的耦合研究
15.
RUGGEDNESS. Automotive ring gear differential. Axle shafts on roller bearings.
强度：自动差速齿轮，滚子轴承上的刚性车轴。
16.
Experimental Study on Dynamic Strength and Deformation of Concrete Under Uniaxial and Blaxial Action;
混凝土单轴、双轴动态强度和变形试验研究
17.
The Performance Analysis of Diesel Crankshaft and the Research for Calculation Method of Crankshaft Fatigue Strength;
柴油机曲轴性能分析及曲轴强度计算方法研究
18.
Calculation of Dynamic Stress and Fatigue Strength of Crankshaft with Bush Deformation Included
计入轴瓦变形的曲轴动应力和疲劳强度计算