1.
The joint formed by welding.
焊接点通过焊接形成的接合点
2.
creating a butt joint by welding.
通过焊接产生对接接头的焊接。
3.
openings through welded joints
通过焊接连接处的开孔
4.
To achieve the required bump heights, the solder paste is over-printed onto the wafer bond pads.
为了获得要求的凸起高度，锡膏在晶片焊盘过焊。
5.
insufficient or excess reinforcement of weld
加强焊缝不足或过量
6.
Effects of Short-Circuit Transfer on Formation of Weld Under High Speed Welding
高速焊短路过渡过程对焊缝成形影响分析
7.
Through the algorithms, robot can weld the workpiece on downhand welding position, which is easer to ensure the good welding quality.
通过机器人系统的运动学和平焊位置算法,可以实现焊缝在平焊位置焊接,从而保证了焊接质量.
8.
Use a blast cleaner or power tool to remove weld flux slag, weld metal spatters, weld flux fume deposits, rust and damaged paint film in welded areas.
通过喷砂或电动工具除去焊渣、飞溅焊烟、锈迹和焊接部损坏的漆膜。
9.
Seam Distinguishing System & Automatic Control of Two-join-one Welding Equipment for Movable Steel Tube;
移动式钢管“二接一”焊接装置的焊缝识别系统与焊接过程自动化
10.
Electrocircuit and time controlled precisly to improve the quality of welding.
焊接过程中电流和时间精密控制，提高焊接质量。
11.
Study of Droplet Transfer and Formation s Experiment of Welding Joint in Plasma-MIG Welding;
Plasma-MIG焊接熔滴过渡及焊缝成形的实验研究
12.
The Generation Process and Suppression of Humping Bead in High-speed GMAW
高速GMAW焊接驼峰焊道的产生过程及抑制
13.
Vision-based Sensing of Humping Bead Formation during High Speed GMAW
高速GMAW焊驼峰焊道形成过程的视觉检测
14.
The Quality Control of Pressure Vessel to Take Over the Welding Process of Welding
压力容器接管焊接过程中焊接质量的控制
15.
Influence of Welding Parameters on Process Control of Meso-Spray Transfer in Pulsed-MIG Welding of Aluminum
焊接参数对铝脉冲MIG焊亚射流过程控制的影响
16.
Simulation of the microstructure evolution of welding-grain growth in heat affected zone
焊接过程组织演变——模拟焊接热影响区晶粒长大
17.
Study on Push & Pull Feeding System and Process Exactly Control for CO_2 Short Circuit Welding
推拉丝短路过渡CO_2焊焊接系统及过程精密控制研究
18.
Seat ring is seal welded to eliminate leak path.
阀座环通过密封焊接，消除泄漏通道。