1.
Applying Heaviside function, the equations governing the beam that possessing spatially distributed piezoelectric patches have been established.
首先借助阶梯函数，建立了含有任意分布的用作执行器的压电片的梁挠曲轴线方程。
2.
A Discussion on the Main Axis Analysis Method Modeling of the Conic;
二次曲线主轴方程的解析法建模研讨
3.
A New Method for the Optimization of Practical Process System --Nonlinear Mapping Principal Axis Analysis Method
过程系统寻优新方法——非线性映射主轴分析法
4.
New inference method of the optic axial angle and the ray axial angle of the negative biaxial crystal
负双轴晶体光轴角和光线轴角推导的新方法
5.
Initial-boundary Value Problem for Beam Equation Under Nonlinear Force Joint with Axial Force
非线性势力与轴向力联合作用下梁方程的初边值问题
6.
It has an elaborate threading process that uses three spools of thread.
它的穿线过程很复杂,要用三个线轴。
7.
Study of the Rule of Train Axle Temperature and Infrared Detection Mode of Axle Temperature;
列车轴温规律及红外线轴温探测方式的研究
8.
The large scale bend axis piston pump axial setting and pump package centre adjusting method
大型斜轴泵轴线设置与泵组中心调整方法
9.
Research and Application on the Tool-axis Vector Control during the 5-axis CNC Programming based on MasterCAM 9.0
基于MasterCAM 9.0五轴编程刀轴矢量控制方法及应用
10.
However, there are two possible axial directions.
不过，沿着轴线也还有两种可能的方向。
11.
Vertical axis type elevation-azimuth antenna pedestal
立轴式俯仰-方位型天线座
12.
Analysis on the Axis Application in the Chinese and Western Royal Gardens;
试论轴线在中西方帝王园林中的应用
13.
The Theory and Practice Research of City Axis Design;
城市轴线设计方法的理论与实践探索
14.
Study on Three Dimension Modeling Method for Involute Spline of Torsion Shaft
扭力轴渐开线花键三维建模方法研究
15.
Online Detection Method for Camshaft Machining Error
凸轮轴加工的误差在线测量方法研究
16.
Discussion on Shaft Current On-line Monitoring of Hydro-generators
水轮发电机轴电流在线监测方案探讨
17.
Application of FDM Method in the Numerical Simulation of Square Coaxial Lines
有限差分法在方同轴线仿真中的应用
18.
Method of Determining Cental Line and Axis Line of Inclined Well Winch of Coal Mine
煤矿大斜井绞车增型中心线及轴线给定方法