1.
Third Harmonic Injection Control Strategy of Improved Z-Source Inverter
改进Z源逆变器的三次谐波注入控制策略
2.
Adaptive Damping Injection Control of Permanent Magnet Synchronous Motor Based on Hamiltonian System Theory
基于哈密顿系统原理的PMSM自适应阻尼注入控制
3.
Research on Fault Injection of Control and Monitor Program of Synthetic Aperture Radar;
星载SAR控制软件故障注入技术研究
4.
Design of the Large Tilt Ion Implanter Control System Software
大角度离子注入机控制系统软件设计
5.
DC voltage control of single injection active power filter
单独注入式APF直流侧电压的稳定控制
6.
Development of Controller of Hybrid Active Power Filter with Injection Circuit
注入式混合型有源电力滤波器控制器的研制
7.
The molten metal may enter the ingot mould in two ways: from the top and from the bottom. Top pouring is the simplest and cheapest method, but gives poor control over the rate of pouring.
钢液注入钢锭模可采用两种方式:上注和下注。上注法最简单，成本最低，但不好控制浇注速度。
8.
Preparation of AIN Film by Medium Frequency Sputtering and Investigation of Ions Implanted AIN Film;
中频磁控溅射制备AIN薄膜及其离子注入研究
9.
Research on Three-Phase Single-Switch Boost Type Harmonic Injection PFC Rectifier Based on One-Cycle-Control Technique;
单周期控制的三相单管谐波注入式PFC电路研究
10.
Study of Medical Microinjection Equipment Based on AVR SCM;
基于AVR单片机控制的医学微量注入仪器的研究
11.
Corrosion Mechanism and Indicator Control for CO2 in Injection Waters of Jianghan Oil Region;
江汉油区注入水中二氧化碳腐蚀与指标控制
12.
Research on Polymer Flooding Injection Quality Control Systems Engineering Methods
聚驱注入体系质量控制系统工程方法研究
13.
Modeling and Control of MLCR-CSC Based on STATCOM
基于多级注入式电流源型STATCOM的建模与控制
14.
Simulation of Multi-Segment Injection Line Control on Flow Front for VARI
注入线分段控制对VARI中流动前沿的模拟
15.
Compound Control Method for Single Injected Active Power Filter
单独注入式有源滤波器的新型复合控制方法
16.
Design and implementation of fault injector based on CPLD
基于CPLD控制的故障注入器的设计与实现
17.
Modeling and Control of STATCOM Based on Multi-Level Reinjection Current Source Converter
基于多级注入式电流源变换器的STATCOM建模与控制
18.
Dual-Loop Control Strategy of Hybrid Active Power Filter With Injection Circuit
注入式混合型有源电力滤波器双闭环控制