1.
"The furnace is equipped with a high efficiency compact spray cooling device with high cooling capacity, high cooling rate and good uniformity, by which the length of the cooling zone is reduced. "
采用高效紧凑式喷射冷却装置,冷却能力大,速度快,冷却均匀,大大缩短了冷却段的长度
2.
The annealed strip is cooled to the temperature required by galvanizing process in the cooling zone and then goes into zinc pot through sealed channel.
将退火带钢在冷却段冷却到指定温度,经密封通道进入锌锅。
3.
The cooling section is the third heat exchanger of the system and is designed to use a cooling medium to reduce the product to the desired temperature, typically near the temperature at which it will be packaged and stored.
冷却段为设备中第三个热交换器,用冷却介质将产品降到要求的特别接近包装和储存的温度。
4.
The regeneration, heating, and cooling sections of the pasteurization system are heat exchangers.
巴氏杀菌设备的回流、加热和冷却段均为热交换器。
5.
taking-down period
(玻璃液)冷却阶段
6.
Cooling between stages is necessary.
各段之间需要冷却。
7.
Nonlinear Behavior of Steel Structures Considering the Cooling Phase of A Fire
火灾后冷却阶段钢结构的非线性性能
8.
Microstructure Evolution of Low-Carbon Si-Mn TRIP Steel During Step Cooling
TRIP钢在分段冷却过程中的相变行为
9.
The newly developed cooling system has a high efficient two stage radiator.
最新被开发的冷却系统拥有高效率的两阶段冷却。
10.
FEM Numerical Simulation on Temperature Field of Injection Molding in Cooling Stage;
住塑模冷却阶段三维温度场的有限元模拟
11.
Influence of Subsection Cooling Process on Mechanical Properties of Low Carbon Medium Plate
分段冷却工艺对低碳钢中板力学性能的影响
12.
Reducing the Yield Ratio of Steel Plate for Welded Gas Cylinders by Two-stage Cooling in Baosteel's Hot Strip Mill
宝钢热连轧两段冷却降低气瓶钢屈强比
13.
Experimental investigation of behavior of steel beams with axial restraint in cooling phase at elevated temperature
高温下约束钢梁冷却阶段的性能试验研究
14.
Discussion for Quickly Cooling Pig Carcass by Two Steps
猪白条肉二阶段快速冷却中一些问题的探讨
15.
Application of Roll Stepped Cooling Technology for Sheet Shape Control in Angang 1 450 mm Continuous Cold Roliing Mills
轧辊分段冷却技术在鞍钢1450板形控制中的应用
16.
Analysis and design of the fluid state of the section of duct pervasion in the mechanical ventilation cooling tower
机械通风冷却塔风筒扩散段的流态分析与设计
17.
The laminar Cooling Control Strategy and Model Identification of the Steckel Mill
炉卷轧机层流冷却系统的控制策略及精冷段系统辨识
18.
condenser air cooling
(空气冷却) 冷凝管