1.
DRILLING AND COMPLETION DAMAGE MODEL OF FRACTURED AND LOSS CARBONATE GAS RESERVOIR
裂缝漏失性碳酸盐岩气藏钻井完井损害模式
2.
Progress in the Numerical Simulation of Invasion Damage from Drill-in Fluids in Horizontal Wells
水平井钻井完井液侵入损害数值模拟研究进展
3.
Analysis of permeability damage well drilling and finishing in underground layer around oil well
钻井与完井对近井地层渗透性损伤的分析
4.
Study on residual strength of wearing casing in deep and ultra-deep wells
深井、超深井套管磨损后剩余强度分析
5.
Freeze Sinking Sidewall's Stress Analysis Considering Damage under Complicated Load;
复杂荷载下冻结凿井井壁损伤应力分析
6.
ADVANCED MIT-MTT LOGGING TECHNOLOGY FOR PIPE STRING DAMAGE DETECTION AND APPLICATION
先进的MIT-MTT井下管柱损伤测井技术及应用
7.
Development and Application of Basket Barrel Overshot of Breakage Oil Pipe in Water-Oil Well
油水井井下破损油管打捞筒研制与应用
8.
Using Caliper Imaging Logging to Evaluate Casing Damage Mechanism of Wenmi Oilfield
用井径成像测井评价温米油田套损机理
9.
Casing failure mechanism and strength design considerations for deep and ultra-deep wells
深井超深井套管损坏机理与强度设计考虑因素
10.
Technique of tapping the potential of residual oil in casing damage wells based on side tracking
套损井开窗侧钻水平井挖潜剩余油技术
11.
Based on the outcome of 40-armed caliper log analysis, suggestions on casing failure well repairing has been put forward.
根据40臂井径测井资料解释成果，提出了对套损井检修建议。
12.
Both the derrick deviation and the wellheads eccentricity will cause the serious wearing of the casing (or casing protecting tube) close to the wellhead.
井架不正或井口偏心，会造成近井口套管（或套管防磨套）的磨损。
13.
In order to study the theory of casing damage and reduce the casing damage of oil-water wells, a new log analysis method of multi-armed caliper log is expounded.
为了深入研究套损机理，减少油水井套管的损坏，提出了新的多臂井径测井解释方法。
14.
Assessment on Mine Air Quality Using Pollution Loss Rate
污染损失率法评价矿山井下空气质量
15.
Causes of Intermediate Casing Damage and Treatments in Sha 84 Well
沙84井技术套管破损原因分析及处理
16.
STUDY ON THE PRESSURE LOSS LAWS IN MICRO HOLE CIRCULATORY SYSTEM
微小井眼循环系统压力损失规律研究
17.
The Joshi formula considering the friction loss of well bore
考虑井筒摩阻损失后的Joshi公式
18.
Investigation on Calculate Method of Depth of Wearing of Rod and Tubing on Sucker Rod Pump Wells
抽油机井杆管磨损深度计算方法研究