1.
Analysis of influencing factors of preliminary screening of high yield biosurfactant-producing bacteria by oil spreading method
生物表面活性剂高产菌用排油圈法初筛时的影响因素分析
2.
Improvement and Application of Oil Spreading to Detect Biosurfactant
生物表面活性剂排油圈检测方法的改进和应用
3.
Design and Develop of Alloy Valve Seat Insert (VSI) in the Engine of Lead-Free Gasoline;
无铅汽油发动机合金排气阀座圈的设计及研制
4.
Design and Study of Valve Seat Insert Which Used for Automobile Engine of Lead Free Gasoline;
无铅汽油发动机双层排气阀座圈的设计及研制
5.
APPLICATION OF TRAP ASSESSMENT TO HYDROCARBON PROSPECTING IN TURPAN DEPRESSION
圈闭评价法在吐鲁番坳陷油气勘探中的应用
6.
Discuss on Investment Method of Productivity Construction in Niu Quanhu Oilfield;
降低牛圈湖油田产能建设投资方法探讨
7.
MECHANISM AND SOLUTION OF RING-FORMING OF PETROLEUM COKE IN A 50m ROTARY KILN
浅谈50m回转窑内石油焦结圈机理及解决方法
8.
Recognition method for low-relief structural trap at AT11 well field of Tahe oilfield
塔河油田AT11井区低幅度构造圈闭的识别方法
9.
Butter an8-9- inch bowl and place slices of biscuit roll from around the sides, fitting them tightly together so that there are no spaces for the filling to seep through.
将蛋糕卷排入一个抹油的8-9寸碗具，尽量将蛋糕圈都排得紧凑些，这样慕斯馅不会过多渗出来。
10.
Measurement method for emission pollutants of exhaust gas of marine diesel engine
GB/T15097-1994船用柴油机排气排放污染物测量方法
11.
Study on Diesel Engine Exhaust After-treatment Technologies Meeting Euro Ⅳ/Ⅴ Standards
满足欧Ⅳ/Ⅴ排放法规的柴油机排气后处理技术
12.
A Study of the Measurement on-Board Ship of Fuel Consumption for Emission Control;
柴油机排放实船测试中油耗测量方法的研究
13.
Diesel engine--Exhaust smoke measurement method at steady state
GB9486-1988柴油机稳态排气烟度及测定方法
14.
Measurement method for exhaust gas smoke of marine diesel engine
GB/T5741-1985船用柴油机排气烟度测量方法
15.
Research on the improvement ideas of gasoline engine transient emission mode method
汽油机瞬态排放工况法改进思路研究
16.
The Fully Cycle Extensibility of K_(1,4)-restricted Graphs and Methods for Ranking in Multi-attribute Decision-making;
K_（1，4）-受限图的完全圈可扩性与多属性决策的方案排序法
17.
Research on Calculation Method of Buried Pipe Foundation Melting Laps in Permafrost of Sino-Russian oil Pipeline
中俄输油管线多年冻土埋地管道地基融化圈计算方法研究
18.
Processing Method of Intercrossing Lubricating Oil Grooves in Inner-spheral Surface of Bearing Outer Ring
轴承外圈内球面上交叉润滑油槽的加工方法探讨