1.
Pressure Calibration for Two-stage Large-volume Multianvil Press Based on Cubic Press by Resistance Measurement of Manganin
用锰铜电阻法标定基于国产铰链式六面顶压机的二级6-8型大腔体高压装置的压力
2.
Design and Temperature Calibration for Heater Cell of Split-Sphere High Pressure Apparatus Based on the Hinge-Type Cubic-Anvil Press
基于铰链式六面顶压机的二级6-8模超高压大腔体内置加热元件的设计与温度标定
3.
Thus we completed the full set of relative instantaneous dwells for each link of various type planar six-bar linkges.
因而完成了各类平面铰链六杆机构构件瞬时停歇的全集。
4.
The Reliability Analysis for 20000kN Static Presser s Hinge Sleeve System;
20000kN静压机铰链梁系统的可靠性分析
5.
a pedestal table whose top is hinged so that it can be tilted to a vertical position.
顶部有可以斜翘成直面的铰链的旋转桌。
6.
Optimization of Hinge Point for Direct-lift Construction;
直顶式举升机构铰支点位置优化设计
7.
The Dynamics and Control Design of Planar Four-bar Mechanism;
平面铰链四杆机构的动力和控制设计
8.
A dynamic solution for a planar linkage five-bar mechanism with Matlab
平面铰链五杆机构的Matlab动力学求解
9.
Study on temperature of different assembly structure in cubic hinge apparatus
六面顶压机上不同组装结构的温度研究
10.
An Analysis of Mechanical Performance of Flexural Hinges In Bender;
压弯微调机构中柔性铰链的机械性能分析
11.
Preparation of AlN Piezoelectric Thin Films and a Hinged Micromachined Piezoresistive High-g Accelerometer;
AlN压电薄膜制备及铰链式高量程加速度计研究
12.
Mechanical analysis on the flexural hinge-based bender in monochromator;
单色器中柔性铰链压弯微调机构的力学分析
13.
hydrautorque-hinge hatchcover
液压扭转铰链舱口盖
14.
Discussions on Conditions of Plane Hinge Four-bar Mechanism with Crank;
平面铰链四杆机构具有曲柄的条件推导及讨论
15.
hood hinge rod bracket
机罩的铰链拉杆支架
16.
The Effect of Hexa-orientation Press Control System Development on Grade and Carbide Anvil Consumption
六面顶压机控制系统的发展对金刚石品级和锤耗的影响
17.
Position hinge plates, shims and replacement hinge-half on door face.
在车身表面定位铰链护板，填隙片和半铰链。
18.
Low-temperature model test of static ice pressure on articulating slope protection system
静冰压力对铰链式护坡系统作用的低温模型试验