说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 低有机负荷
1.
Preliminary Test of Wastewater Treatment Plant with CAST Craft at Low Temperature and Low Nutrition
CAST工艺在低水温低有机负荷条件下的启动调试
2.
THE ADJUSTED PRACTICE OF OPERATIONAL PARAMETERS OF THREE-TANK OXIDATION DITCH UNDER LOW ORGANIC LOADING
低有机负荷下三槽式氧化沟运行参数的调整实践
3.
Using Filamentous Bacteria and Membrane Sepration Technology to Treating Domestic Wastewater under Low Load
低有机负荷下利用丝状菌和膜分离技术处理生活污水
4.
Negative Control Effects of UFLS and UVLS
低频低压切负荷的控制负效应及其机理
5.
Study on Part-load Operation of 300MW CFB Unit
300MW CFB机组低负荷运行研究
6.
Treatment of overproof dissolved oxygen in condensate of 1000 MW unit at low-load operation
1000MW机组低负荷凝结水溶氧超标的治理
7.
Electrical networks in the villiages have characteristics of load decentralization ,strong seasonality ,lower average loading rate ,and etc.
农村电网具有负荷分散、季节性强、平均负荷率低等特点。
8.
Calcium channel blockers reduce afterload with little effect on preload.
钙通道阻滞剂降低后负荷,而对前负荷几乎没有作用。
9.
Study on Security of Water Circulation under Low Load Operation of 300MW Boiler;
300MW锅炉机组低负荷运行水循环安全性研究
10.
Discussion on energy saving control mode under low load operation of power units;
机组在低负荷运行下的节能控制方式探讨
11.
Reasonably distributing unit loads to reduce average coal consumption for power supply;
合理分配电网机组负荷,降低平均供电煤耗
12.
Study to Advance Ability Vibration Abasement Crusher of Circulate Burden
提高筛分效率降低破碎机循环负荷的研究
13.
The Characteristics of Combustion in the Boiler of a Ningdian 1000MW Unit Phase Ⅱ
宁海电厂二期1000MW机组锅炉低负荷燃烧特性
14.
Underrating has the advantage of increasing physical life.
低负荷运行具有能延长物理寿命的优点。
15.
The total weight of passengers and cargo that an aircraft carries or can carry.
有效负荷飞机负荷或所能载运的旅客和货物总重
16.
STUDY OF MULTI-STAGE LOW-REACTION HIGHLY LOADED AXIAL COMPRESSOR AND ITS INTERNAL FLOW MECHANISM
多级低反动度高负荷轴流压气机及其内部流动机理研究
17.
When the load is lower than the standard, the cost will be given to users as an allowance.
路段交通负荷低于路段负荷标准时补贴给用户。
18.
In the range, the engine sp eed is required to be set higher and the load should be set lower.
在该区间内,要求发动机应采用较高转速,较低的负荷.