1.
The Node City-Axis Development Mode and the Formation of Nanning-Guiyang-Kunming Economic Area;
节点城市—轴线开发模式与南贵昆经济区形成
2.
The Development of the On-line Straightness Detection System for Shafts
轴类工件直线度在线检测系统的开发
3.
Research & Development of Multi-axis Motion Controller Based on PCI Bus;
基于PCI总线的多轴运动控制器的研究与开发
4.
Research and Development of Off-line 3-axis Motion Control System Based on DSP
基于DSP的离线式三轴运动控制系统研究与开发
5.
THE DEVELOPMENT MODEL IN TOURISM RESOURCES OF QINGHAI-TIBET BASED ON THE POLE-AXIS SYSTEM THEORY
青藏铁路沿线旅游资源“点—轴”开发模式研究
6.
Telecentric operation (field rays leave parallel to optical axis, unlike Barlow lenses which diverge rays).
远心手术（场射线离开平行光轴，不像巴卢镜片，其中发散射线）。
7.
duplexer of coaxial line system
同轴线收发转换装置
8.
Development of the Loaded State of Oil Film of Wire Stock High-speed Rolling Mill and Simulation Test System;
线材高速轧机油膜轴承承载状态与仿真测试系统开发
9.
Unplug the antenna coaxial cable connector from the radio chassis.
从收音机底盘拔开天线同轴导线。
10.
Pilot Production of Bearing Steel GCr15SiMn at Shijiazhuang Steel
石钢GCr15SiMn轴承钢的开发
11.
Shape Optimization of Transition Curve of Shoudle of Step-Shaped Shaft and Its Experimental Research;
阶梯轴轴肩过渡曲线的开头优化及实验研究
12.
" Switches(coaxial), RF transmission line, general specification for"
GB/T13416-1992射频传输线(同轴)开关总规范
13.
Study on Three Dimension Modeling Method for Involute Spline of Torsion Shaft
扭力轴渐开线花键三维建模方法研究
14.
Design and Calculation of Main Shaft for Uncoiler of Coating Test Line
涂层试验线开卷机主轴的设计与计算
15.
The results show that at room temperature coal particles disperse widely in the drop-tube furnace, while at high operating temperature they don't so.
但是,实验中发现,颗粒在紧靠轴线进入层流气体反应区后,很快弥散开来。
16.
Development and Property Analysis of Hi-performance Gas Transmission Linepipes under High Pressure and Axial Strain(Part Ⅲ)
承受高压及轴向应变的高性能输气管线用钢管的开发和性能分析(下)
17.
Development and Property Analysis of Hi-performance Gas Transmission Linepipes under High Pressure and High Strain(Part I)
承受高压及轴向应变的高性能输气管线用钢管的开发和性能分析(上)
18.
engine and transmission alignment checking device
发动机和变速器轴线检查仪