1.
large core high numerical aperture fiber
大芯径大数值孔径光纤
2.
Hence the value of high numerical aperture for such specimens.
因此对这标本需采用大数值孔径的物镜。
3.
Research on Craft of Large Numerical Aperture Multiple-Composition Glass Flexible Fiber;
大数值孔径多组分玻璃柔性光纤工艺的研究
4.
Numerical Simulation of Load Convey Mechanism of Large Diameter Super-Long Pile;
大直径超长钻孔灌注桩荷载传递机理的数值模拟研究
5.
Numerical Solution of the Limited Aperture Problem in Three-Dimensional Inverse Acoustic Scattering
三维有限孔径逆声散射问题的数值解
6.
diameter and number of hole
喷嘴量孔孔径及数目
7.
Pass Design and Application of Thin Diameter Tantalum Wire Rolling Based on Numerical Simulation;
基于数值模拟的细径钽丝轧制孔型设计与应用
8.
A new method for measurement of numerical aperture of photonic crystal fibers
光子晶体光纤数值孔径测试的一种新方法
9.
The simulation of photo scanning tunnel microscopy image with a metal nano-rod afflicted to an aperture fiber probe
带纳米金属棒PSTM孔径光纤探针成像的数值模拟
10.
Numerical Simulation of Heat-Transfer Characteristics of Swirling Impinging Jet with Micro-Aperture
微小孔径旋转冲击射流换热特性的数值模拟
11.
Simulation of effect on flow by diameter of loop reactor distributor's aperture
环流反应器分布器孔径对流场影响的数值模拟
12.
Generation and Focusing Property with High-Numerical Aperture Lens of Vectorial Polarized Beam
矢量偏振光束的产生及其高数值孔径聚焦性质
13.
The relation is discussed between the shift of the point of maximum intensity on axis from the waist of focused Gaussian beam and the radius of the diffracted aperture, and the parameters of the Gaussian beam.
讨论了轴上点光强最大值相对会聚高斯光束束腰的偏移量同衍射孔径及高斯光束参数的关系。
14.
Numerical simulation of injecting cement design parameters for the large diameter bored pile
大直径钻埋桩压浆设计参数数值仿真
15.
Results from Measurements of Large Aperture Scintillometer over Different Surfaces
不同下垫面大孔径闪烁仪观测数据处理与分析
16.
FEM Simulation Research on Large-Sized Straight Weld Pipe's Rounding and Sizing Process
大口径直缝焊管整圆定径工艺数值模拟研究
17.
Numerical Simulation of Rounding-sizing Process of Large-sized Straight Welded Pipe
大口径直缝焊管整圆定径工艺过程的数值模拟
18.
Generally, an aperture radius of two to three times the FWHM of the PSF is a good value.
一般的，孔半径设置为点扩展函数的半宽值的两到三倍比较好。