1.
The Application of Image Recognition Method Based on Hu-moment Invariants in Auto-pouring System
Hu不变矩识别算法在自动浇注系统中的应用
2.
Study on Constant Volume Weight Control Technology for Pb-Ca Alloy Automatic Casting System(Cound.)
铅钙合金自动浇注系统恒容重控制技术研究(续)
3.
Study on Constant Volume Weight Control Technology for Pb-Ca Alloy Automatic Casting System
铅钙合金自动浇注系统恒容重控制技术研究
4.
Design of Pb-Ca Alloy Automatic Casting System Based on The S7-300PLC
直线往复式铅钙合金自动浇注系统设计
5.
Design of auto-stripping injection mould with parting-out in sequence and pin gate mechanism
顺序分型点浇口自动脱料注射模设计
6.
Relationship between rheological properties and flowability of corundum based self-flow castables
刚玉质自流浇注料流变性和流动性的关系
7.
Design of Auto-Sheared Injection Mold for Edge Gate of FPD Cabinets
自动切除平板电视面框侧浇口废料的注射模设计
8.
"After each 10 m long Base part-section is concreted, the TVM 18 is relocated, after each roadway surface concreting cycle, the pipe Bridge is moved."
"每浇注10米基底,就移动TVM18, 浇注完一块路面板后,移动管道桥。"
9.
It's mainly used in ladle backing layer and tundish backing layer.
自流浇注料还可采用机械化施工。
10.
The concrete pump is only relocated after a number of sections have been completed.
浇注完数段路面板后,才移动混凝土泵。
11.
Preparation of Mg-Ni-Si Metallic Glass by Vibration Casting Process;
震动浇注法制备Mg-Ni-Si金属玻璃
12.
Rheological property of bauxite based Al_2O_3-MgO vibration castable
矾土基Al_2O_3-MgO质振动浇注料的流变性能
13.
Research and appliance of new technology of casting babbitt alloy bearing
滑动轴承合金浇注新工艺研究及应用
14.
Optimization of feed system and design of injection mould for automotive engine cover
汽车发动机罩盖浇注系统优化与注射模设计
15.
Influencing Factors and Improving Measures of Automatic Pouring in Small Ladle
影响钢包自动开浇的因素及改进措施
16.
The flow rate, beams result shows the amount and rate of polymer that is delivered through runners into the mold cavity, allowing you to optimize the runner system design.
柱体元素流动率?示柱体元素内塑料的流动率，主要是浇注系统，为优化浇注系统提供依据。
17.
A cement mixer agitates the cement until it is ready to pour.
水泥搅拌工一直搅动水泥，直到它能浇注为止。
18.
Study on Dynamic Performance of Cast Polyurethane Elastomers with High Property
高性能浇注型聚氨酯弹性体的动态性能研究