1.
Design for Realtime Tracking-Control System of Two-Shaft Turntable;
变负载两轴转台实时跟踪控制系统的设计
2.
This means that the crankshaft will make two revolutions for every revolution of the camshaft.
这意味着凸轮轴每旋转一次曲轴将旋转两次。
3.
Research on Position Alignment Method of a Three-axis Simulator
三轴转台三轴交汇中心位置对准方法的研究
4.
A pin or gudgeon, especially either of two small cylindrical projections on a cannon forming an axis on which it pivots.
炮耳轴或耳轴，尤指炮两边形成旋转中轴的两个圆柱形小突起
5.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
6.
Analysis on Critical Technologies for Two-Axis Strap-Down Stabilized Tracing Platform
两轴捷联稳定跟踪平台关键技术分析
7.
Figure 14. 7 shows a typical three-axis universal stage.
图14．7表示一个典型的三轴万能旋转台。
8.
ANALYSIS OF THE THREE-AXIS TURNTABLE ABOUT THE MODEL AND THE STATIC STRESS;
大型三轴转台的建模及静态力学分析
9.
Dynamic Analysis and Testing on Spacail Two-Axis Turntable
空间二轴转台动力学分析和试验研究
10.
The Research of Balance Mechanism of Compound Turntable in Five-axis Machine Tool
五轴机床复合式转台平衡机构的研究
11.
Research of Three-Axis Turntable's Control System Based on RTX
基于RTX的三轴转台控制系统研究
12.
The Research and Development of a Test Stand for Slewing Bearings Applied in a Wind Turbine Generator
风电转盘轴承综合性能实验台的研制
13.
"Essentially, the steering gear consists of two parts, a worm on the end of the steering shaft and a pitmanarm shaft on which there is a gear sector, toothed roller, or stud."
转向器基本上由两部分组成:装在转向轴末端的蜗杆和转向摇臂轴。
14.
Structure and Working Principle of NC Two-axis Rotary Table
数控双转轴式回转工作台的结构与工作原理
15.
contrarotating propeller
同心套轴的两个对转螺旋桨
16.
contra turning propeller
同心套轴的两上对转螺旋桨
17.
Traction Axis with2 motors,2 pinions, rack and clearance electronic take up.
牵引轴配备两台电机，两个小齿轮，台架以及电子设备安装空间。
18.
Design and Dynamic Analysis for Multi-Support Rotor-Bearing System Bearing Load Identification Test-Bed;
多支承转子—轴承系统轴承负荷辨识试验台设计及其动力学分析