1.
The rear swingarm is supported on large pivot bearings, and it felt satisfyingly firm and rigid.
后叉部分则以大型转轴培林与主车架连结，感觉相当的牢固。
2.
ANALYSIS OF THE THREE-AXIS TURNTABLE ABOUT THE MODEL AND THE STATIC STRESS;
大型三轴转台的建模及静态力学分析
3.
Dynamic Analysis for Rotor-Bearing Systems of Large General Machinery
大型通用机械转子—轴承系统的动力学分析
4.
The Repairing of Wearing Rotor Shaft Neck of Large Generator by Friction & Spray Electroplating
大型发电机转子轴颈磨损的摩擦电喷镀修复
5.
Fault diagnosis and repair technique of the large-scale slewing bearing
大型回转支撑轴承故障检测及修复工艺
6.
coaxial N type adapter N
型同轴线接头转接器
7.
Analysis on Accident of Main Shaft Bending of HP-IP Rotors in Large Steam Turbine and its Countermeasures
大型汽轮机高中压转子大轴弯曲事故分析及对策
8.
Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.
大多数轴承都支承径向或轴向负荷的转轴。
9.
any of various shafts that rotate or serve as axes for larger rotating parts.
作为大的旋转零件的轴的各种轴。
10.
This article introduces method of deformanon control of plane P during the welding of a large split runner without main shaft.
介绍了大型分瓣转轮无主轴焊接P平面变形控制的方法。
11.
The Simulating Research on Active Control to the Low Frequency Vibration of a Large Rotor Shaft System with Multi-support;
大型多支承旋转轴系低频振动主动控制模拟研究
12.
Large Slew Bearing Condition Monitoring and Management Research Based on Virtual Instrument;
基于虚拟仪器的大型回转轴承状态监测与管理对策研究
13.
The shaft and discs rotate at about forty revolutions per second.
竖轴和磁盘每秒钟大约旋转40转。
14.
Design of Kinematics Model of Five-axis Machine Tools with Titling Axis
倾斜旋转轴五轴机床运动学模型的设计
15.
hydrodynamic aided rotary shaft lip seal
流体动力型旋转轴唇形密封圈
16.
Figure 14. 7 shows a typical three-axis universal stage.
图14．7表示一个典型的三轴万能旋转台。
17.
Study on the Dynamic Characteristics of Micro Bearing-Rotor System;
微型轴承—转子系统动力特性的研究
18.
Study on the Casting Process of the CCDZ50 Type Bogie s Axle Box;
CCDZ50型转向架轴箱铸造工艺研究