1.
Study on Die of Piston Casting Machine Based on ProCAST
基于ProCAST的活塞浇注机模具研究
2.
Others: Numerical control pouring machine, Gravity die casting machine.
其它设备：数控浇注机，金属型重力铸造型机等。
3.
Rebuilding a Electric Control System of HLZ10C Piston Casting Machine
HLZ10C型活塞浇注机电气控制系统温控改进设计
4.
A new casting technology for inlet manifold in tilt casting machine for gravity die casting was described.
介绍了在可倾式金属型浇注机上制造进气歧管的铸造新工艺。
5.
concreting boom
浇注混凝土起重机臂
6.
It's mainly used in ladle backing layer and tundish backing layer.
自流浇注料还可采用机械化施工。
7.
Optimization of feed system and design of injection mould for automotive engine cover
汽车发动机罩盖浇注系统优化与注射模设计
8.
THE FIX FOR THE TRANSVERSE DIAMETER OF DIFFERENT INJECTION MOLD'S SPRUE BUSH
不同注塑机注塑模浇口套端面直径的确定
9.
The steamroller levelled off the gravel roadbed and then the concrete was poured.
蒸汽压路机压平碎石路基，然后浇注混凝土。
10.
Study on effect of organic silicon resin on capability of epoxy resin cast
有机硅树脂对环氧树脂浇注体性能的影响
11.
Study on Large Volume Poured Cement Based Low and Intermediate Level Radioactive Waste and Mechanism of Cs Solidified;
中低放废液大体积浇注水泥固化及铯固化机理
12.
Design and Optimize the Running System of Cylinder Block and Numerical Simulation
发动机缸体浇注系统的优化设计与数值模拟
13.
Optimization of Casting Process for Manufacturing Babbitt Metal Bearing Bushings Used in Diesel Engines and Experiment Verification
柴油机轴瓦巴氏合金浇注工艺优化及试验验证
14.
The first of the site concrete pumps with an output of 132 kW is set up several sections to the rear on the already finished concreted roadway surface.
第一台现浇混凝土泵,功率132 kW,放在已浇注混凝土上,距布料机数段路面板处。
15.
The plexiglass product usually may divide into pours the board, squeezes out the board and the mold plastic.
有机玻璃产品通常可以分为浇注板、挤出板和模塑料。
16.
Analysis for pressure cast model and secondary cooling water dynamical model of continuous slab caster in Bao Steel
宝钢板坯连铸机压缩浇注模型及二冷水动态模型剖析
17.
Study on Thermo-mechanical Properties and Behavior of Slag Corrosion Resistance of β-Sialon Containing MgO Based Castables;
含Sialon的MgO基浇注料热机械性能和抗渣侵蚀行为研究
18.
Research on Knowledge-Based-Engineering Pouring-Exhausting-Flooding System Design of Die;
基于KBE的压铸模浇注排溢计算机辅助设计系统研究